[PATCH] ARM: tegra: fix board DT pinmux setup

[Arnd Bergmann]

On Friday 21 March 2014, Stephen Warren wrote:
> From: Stephen Warren <swarren at nvidia.com>
> 
> Neither Tegra114 nor Tegra124 allow "low power mode" to be configured
> on SDIO1 or SDIO3 drive groups. Remove the attempt to configure that
> option from the Dalmore and Venice2 DTs.
> 
> The Venice2 DT contained duplicate configurations for most sdmmc1_*
> pins. Remove the duplicate pins from one of the nodes, and fix the
> configuration since the remaining clk pin is output-only.
> 
> Signed-off-by: Stephen Warren <swarren at nvidia.com>

Applied to fixes-non-critical.

Thanks,

	ARnd