[RFC PATCH 02/12] pci: host: pcie-dra7xx: add support for pcie-dra7xx controller

[Kishon Vijay Abraham I]

On Wednesday 26 March 2014 08:15 PM, Rob Herring wrote:
> On Wed, Mar 26, 2014 at 8:57 AM, Kishon Vijay Abraham I <kishon at ti.com> wrote:
>> Added support for pcie controller in dra7xx. This driver re-uses
>> the designware core code that is already present in kernel.
>>
>> Signed-off-by: Kishon Vijay Abraham I <kishon at ti.com>
>> ---
>>  Documentation/devicetree/bindings/pci/ti-pci.txt |   35 ++
>>  drivers/pci/host/Kconfig                         |   10 +
>>  drivers/pci/host/Makefile                        |    1 +
>>  drivers/pci/host/pcie-dra7xx.c                   |  411 ++++++++++++++++++++++
>>  4 files changed, 457 insertions(+)
>>  create mode 100644 Documentation/devicetree/bindings/pci/ti-pci.txt
>>  create mode 100644 drivers/pci/host/pcie-dra7xx.c
>>
>> diff --git a/Documentation/devicetree/bindings/pci/ti-pci.txt b/Documentation/devicetree/bindings/pci/ti-pci.txt
>> new file mode 100644
>> index 0000000..0528c47
>> --- /dev/null
>> +++ b/Documentation/devicetree/bindings/pci/ti-pci.txt
>> @@ -0,0 +1,35 @@
>> +TI PCI Controllers
>> +
>> +PCIe Designware Controller
>> +This node should have the properties described in "designware-pcie.txt".
>> + - compatible: Should be "ti,dra7xx-pcie""
>> + - reg : Address and length of the register set for the device.
>> + - phys : the phandle for the PHY device (used by generic PHY framework)
>> + - phy-names : the names of the PHY corresponding to the PHYs present in the
>> +   *phy* phandle.
>> + - resets: phandle used if reset is handled be soc
> 
> s/be/by/ ?
> 
>> + - reset-names: name given to the phandle
>> + - ti,device-type: Should be 1 - EP TYPE, 2 - LEG EP TYPE OR 3 - RC TYPE
> 
> I don't think this makes sense. I'd imagine we'd need the binding to
> look quite a bit different if endpoint mode was actually supported. I

right, it makes sense to remove the ti,device-type altogether as this driver
only supports RC.
> think I would start defining endpoint mode with a different compatible
> string and go from there.
> 
>> +
>> +Example:
>> +pcie at 51000000 {
>> +       compatible = "ti,dra7xx-pcie";
>> +       reg = <0x51002000 0x14c>, <0x51000000 0x2000>, <0x4A002540 0x1f>, <0x4A003c24 0x4>, <0x4AE07310 0x4>;
> 
> This is different number of entries from your actual dts. You need to
> define how many reg entries, what they are, and the order.

Ok. Will fix it.

Thanks
Kishon