[PATCH 15/20] ARM: ux500: Add a vmmc regulator through DT for the poped eMMC for href

[Linus Walleij]

On Fri, Mar 21, 2014 at 1:14 PM, Ulf Hansson <ulf.hansson at linaro.org> wrote:

> Add a node in DT for the proper regulator which means we can move away
> from the mmci platform data which currently holds the corresponding OCR
> mask.
>
> The mmci driver can then calculate the OCR mask based on the voltages
> supported by the regulator, instead of relying on the platform data.
>
> Signed-off-by: Ulf Hansson <ulf.hansson at linaro.org>
> ---
>  arch/arm/boot/dts/ste-href.dtsi |    1 +
>  1 file changed, 1 insertion(+)
>
> diff --git a/arch/arm/boot/dts/ste-href.dtsi b/arch/arm/boot/dts/ste-href.dtsi
> index be34beb..bf449de 100644
> --- a/arch/arm/boot/dts/ste-href.dtsi
> +++ b/arch/arm/boot/dts/ste-href.dtsi
> @@ -155,6 +155,7 @@
>                         bus-width = <8>;
>                         cap-mmc-highspeed;
>                         non-removable;
> +                       vmmc-supply = <&db8500_vsmps2_reg>;

Don't you need a similar oneliner to ste-snowball.dts?
That board is not including this file...

Acked-by: Linus Walleij <linus.walleij at linaro.org>

Yours,
Linus Walleij