[PATCH] regulator: Add new driver for ST's PWM controlled voltage regulators
Lee Jones
lee.jones at linaro.org
Fri Mar 21 06:21:36 EDT 2014
On some STMicroelectronics hardware reside regulators consisting
partly of a PWM input connected to the feedback loop. As the PWM
duty-cycle is varied the output voltage adapts. This driver
allows us to vary the output voltage by adapting the PWM input
duty-cycle.
Signed-off-by: Lee Jones <lee.jones at linaro.org>
---
drivers/regulator/Kconfig | 6 ++
drivers/regulator/Makefile | 1 +
drivers/regulator/st-pwm.c | 193 +++++++++++++++++++++++++++++++++++++++++++++
3 files changed, 200 insertions(+)
create mode 100644 drivers/regulator/st-pwm.c
diff --git a/drivers/regulator/Kconfig b/drivers/regulator/Kconfig
index 6a79328..a6b29cb 100644
--- a/drivers/regulator/Kconfig
+++ b/drivers/regulator/Kconfig
@@ -432,6 +432,12 @@ config REGULATOR_S5M8767
via I2C bus. S5M8767A have 9 Bucks and 28 LDOs output and
supports DVS mode with 8bits of output voltage control.
+config REGULATOR_ST_PWM
+ tristate "STMicroelectronics PWM voltage regulator"
+ depends on ARCH_STI
+ help
+ This driver supports ST's PWM controlled voltage regulators.
+
config REGULATOR_TI_ABB
tristate "TI Adaptive Body Bias on-chip LDO"
depends on ARCH_OMAP
diff --git a/drivers/regulator/Makefile b/drivers/regulator/Makefile
index 979f9dd..d0c2bb8 100644
--- a/drivers/regulator/Makefile
+++ b/drivers/regulator/Makefile
@@ -59,6 +59,7 @@ obj-$(CONFIG_REGULATOR_PCF50633) += pcf50633-regulator.o
obj-$(CONFIG_REGULATOR_RC5T583) += rc5t583-regulator.o
obj-$(CONFIG_REGULATOR_S2MPS11) += s2mps11.o
obj-$(CONFIG_REGULATOR_S5M8767) += s5m8767.o
+obj-$(CONFIG_REGULATOR_ST_PWM) += st-pwm.o
obj-$(CONFIG_REGULATOR_STW481X_VMMC) += stw481x-vmmc.o
obj-$(CONFIG_REGULATOR_TI_ABB) += ti-abb-regulator.o
obj-$(CONFIG_REGULATOR_TPS6105X) += tps6105x-regulator.o
diff --git a/drivers/regulator/st-pwm.c b/drivers/regulator/st-pwm.c
new file mode 100644
index 0000000..6ef569f
--- /dev/null
+++ b/drivers/regulator/st-pwm.c
@@ -0,0 +1,193 @@
+/*
+ * Regulator driver for ST's PWM Regulators
+ *
+ * Copyright (C) 2014 - STMicroelectronics Inc.
+ *
+ * Author: Lee Jones <lee.jones at linaro.org>
+ *
+ * This program is free software; you can redistribute it and/or modify
+ * it under the terms of the GNU General Public License version 2 as
+ * published by the Free Software Foundation.
+ */
+
+#include <linux/module.h>
+#include <linux/init.h>
+#include <linux/err.h>
+#include <linux/regulator/driver.h>
+#include <linux/regulator/machine.h>
+#include <linux/regulator/of_regulator.h>
+#include <linux/of.h>
+#include <linux/of_device.h>
+#include <linux/pwm.h>
+
+#define ST_PWM_REG_PERIOD 8448
+
+struct st_pwm_regulator_pdata {
+ const struct regulator_desc *desc;
+ struct st_pwm_voltages *duty_cycle_table;
+};
+
+struct st_pwm_regulator_data {
+ const struct st_pwm_regulator_pdata *pdata;
+ struct pwm_device *pwm;
+ bool enabled;
+ int state;
+};
+
+struct st_pwm_voltages {
+ unsigned int uV;
+ unsigned int dutycycle;
+};
+
+static int st_pwm_regulator_get_voltage(struct regulator_dev *dev)
+{
+ struct st_pwm_regulator_data *drvdata = rdev_get_drvdata(dev);
+
+ return drvdata->pdata->duty_cycle_table[drvdata->state].uV;
+}
+
+static int st_pwm_regulator_set_voltage_sel(struct regulator_dev *dev,
+ unsigned selector)
+{
+ struct st_pwm_regulator_data *drvdata = rdev_get_drvdata(dev);
+ int dutycycle;
+ int ret;
+
+ if (selector >= dev->desc->n_voltages)
+ return -EINVAL;
+
+ dutycycle = (ST_PWM_REG_PERIOD / 100) *
+ drvdata->pdata->duty_cycle_table[selector].dutycycle;
+
+ ret = pwm_config(drvdata->pwm, dutycycle, ST_PWM_REG_PERIOD);
+ if (ret) {
+ dev_err(&dev->dev, "Failed to configure PWM\n");
+ return ret;
+ }
+
+ drvdata->state = selector;
+
+ if (!drvdata->enabled) {
+ ret = pwm_enable(drvdata->pwm);
+ if (ret) {
+ dev_err(&dev->dev, "Failed to enable PWM\n");
+ return ret;
+ }
+ drvdata->enabled = true;
+ }
+
+ return 0;
+}
+
+static int st_pwm_regulator_list_voltage(struct regulator_dev *dev,
+ unsigned selector)
+{
+ struct st_pwm_regulator_data *drvdata = rdev_get_drvdata(dev);
+
+ if (selector >= dev->desc->n_voltages)
+ return -EINVAL;
+
+ return drvdata->pdata->duty_cycle_table[selector].uV;
+}
+
+static struct regulator_ops st_pwm_regulator_voltage_ops = {
+ .set_voltage_sel = st_pwm_regulator_set_voltage_sel,
+ .get_voltage = st_pwm_regulator_get_voltage,
+ .list_voltage = st_pwm_regulator_list_voltage,
+ .map_voltage = regulator_map_voltage_iterate,
+};
+
+static struct st_pwm_voltages b2105_duty_cycle_table[] = {
+ { .uV = 1114000, .dutycycle = 0, },
+ { .uV = 1095000, .dutycycle = 10, },
+ { .uV = 1076000, .dutycycle = 20, },
+ { .uV = 1056000, .dutycycle = 30, },
+ { .uV = 1036000, .dutycycle = 40, },
+ { .uV = 1016000, .dutycycle = 50, },
+ /* WARNING: Values above 50% duty-cycle cause boot failures. */
+};
+
+static const struct regulator_desc b2105_desc = {
+ .name = "b2105-pwm-regulator",
+ .ops = &st_pwm_regulator_voltage_ops,
+ .type = REGULATOR_VOLTAGE,
+ .owner = THIS_MODULE,
+ .n_voltages = ARRAY_SIZE(b2105_duty_cycle_table),
+ .supply_name = "pwm",
+};
+
+static const struct st_pwm_regulator_pdata b2105_info = {
+ .desc = &b2105_desc,
+ .duty_cycle_table = b2105_duty_cycle_table,
+};
+
+static struct of_device_id st_pwm_of_match[] = {
+ { .compatible = "st,b2105-pwm-regulator", .data = &b2105_info, },
+ { },
+};
+MODULE_DEVICE_TABLE(of, st_pwm_of_match);
+
+static int st_pwm_regulator_probe(struct platform_device *pdev)
+{
+ struct st_pwm_regulator_data *drvdata;
+ struct regulator_dev *regulator;
+ struct regulator_config config = { };
+ struct device_node *np = pdev->dev.of_node;
+ const struct of_device_id *of_match;
+
+ if (!np) {
+ dev_err(&pdev->dev, "Device Tree node missing\n");
+ return -EINVAL;
+ }
+
+ drvdata = devm_kzalloc(&pdev->dev, sizeof(*drvdata), GFP_KERNEL);
+ if (!drvdata)
+ return -ENOMEM;
+
+ of_match = of_match_device(st_pwm_of_match, &pdev->dev);
+ if (!of_match) {
+ dev_err(&pdev->dev, "failed to match of device\n");
+ return -ENODEV;
+ }
+ drvdata->pdata = of_match->data;
+
+ config.init_data = of_get_regulator_init_data(&pdev->dev, np);
+ if (!config.init_data)
+ return -ENOMEM;
+
+ config.of_node = np;
+ config.dev = &pdev->dev;
+ config.driver_data = drvdata;
+
+ drvdata->pwm = devm_pwm_get(&pdev->dev, NULL);
+ if (IS_ERR(drvdata->pwm)) {
+ dev_err(&pdev->dev, "Failed to get PWM\n");
+ return PTR_ERR(drvdata->pwm);
+ }
+
+ regulator = devm_regulator_register(&pdev->dev,
+ drvdata->pdata->desc, &config);
+ if (IS_ERR(regulator)) {
+ dev_err(&pdev->dev, "Failed to register regulator %s\n",
+ drvdata->pdata->desc->name);
+ return PTR_ERR(regulator);
+ }
+
+ return 0;
+}
+
+static struct platform_driver st_pwm_regulator_driver = {
+ .driver = {
+ .name = "st-pwm-regulator",
+ .owner = THIS_MODULE,
+ .of_match_table = of_match_ptr(st_pwm_of_match),
+ },
+ .probe = st_pwm_regulator_probe,
+};
+
+module_platform_driver(st_pwm_regulator_driver);
+
+MODULE_LICENSE("GPL");
+MODULE_AUTHOR("Lee Jones <lee.jones at linaro.org>");
+MODULE_DESCRIPTION("ST PWM Regulator Driver");
+MODULE_ALIAS("platform:st_pwm-regulator");
--
1.8.3.2
More information about the linux-arm-kernel
mailing list