[PATCHv2] ARM: OMAP2+: Use pdata quirks for wl12xx on the AM335x EV-MSK

[Yegor Yefremov]

Hi Imre,

On 03.03.2014 10:02, Imre Kaloz wrote:
> Enable the WiLink6 connected to mmc2.
> 
> Signed-off-by: Imre Kaloz <kaloz at openwrt.org

I have some trouble with WLAN. If I make extensive scanning (just start NetworkManager and wait a minute or so) I get following errors over and over again:

[  717.608550] wlcore: Scan completed due to error.
[  717.613422] ------------[ cut here ]------------
[  717.618405] WARNING: CPU: 0 PID: 940 at drivers/net/wireless/ti/wlcore/main.c:789 wl12xx_queue_recovery_work+0x60/0x6c()
[  717.629832] Modules linked in:
[  717.633055] CPU: 0 PID: 940 Comm: kworker/u2:2 Tainted: G        W    3.14.0-rc4-12737-gefb78a0-dirty #214
[  717.643264] Workqueue: phy0 wl1271_scan_complete_work
[  717.648649] [<c00151e0>] (unwind_backtrace) from [<c0011e38>] (show_stack+0x10/0x14)
[  717.656762] [<c0011e38>] (show_stack) from [<c05a1944>] (dump_stack+0x7c/0x94)
[  717.664372] [<c05a1944>] (dump_stack) from [<c00402bc>] (warn_slowpath_common+0x6c/0x90)
[  717.672876] [<c00402bc>] (warn_slowpath_common) from [<c004037c>] (warn_slowpath_null+0x1c/0x24)
[  717.682110] [<c004037c>] (warn_slowpath_null) from [<c035be0c>] (wl12xx_queue_recovery_work+0x60/0x6c)
[  717.691889] [<c035be0c>] (wl12xx_queue_recovery_work) from [<c036d804>] (wl1271_scan_complete_work+0xf8/0x108)
[  717.702391] [<c036d804>] (wl1271_scan_complete_work) from [<c0058ff4>] (process_one_work+0x1ac/0x4c4)
[  717.712110] [<c0058ff4>] (process_one_work) from [<c0059e88>] (worker_thread+0x114/0x3b4)
[  717.720707] [<c0059e88>] (worker_thread) from [<c005fa44>] (kthread+0xcc/0xe8)
[  717.728306] [<c005fa44>] (kthread) from [<c000e388>] (ret_from_fork+0x14/0x2c)
[  717.735856] ---[ end trace f4d374bb2ca37664 ]---
[  717.743587] wlcore: Hardware recovery in progress. FW ver: Rev 6.3.10.0.133
[  717.752600] wlcore: pc: 0x0, hint_sts: 0x00000020 count: 6
[  717.759609] wlcore: down
[  717.764108] ieee80211 phy0: Hardware restart was requested
[  718.250930] wlcore: firmware booted (Rev 6.3.10.0.133)

Have you experienced such behavior?

Regards,
Yegor