[PATCH v2 01/16] ASoC: fsl-ssi: Remove fsl_ssi_setup
Markus Pargmann
mpa at pengutronix.de
Sat Mar 15 08:44:09 EDT 2014
fsl_ssi_set_dai_fmt() manages most of the register setup routines now.
fsl_ssi_setup() makes the same as fsl_ssi_set_dai_fmt() but it relies on
DT properties.
In most cases the settings of fsl_ssi_setup() are already overwritten by
fsl_ssi_set_dai_fmt() when it is called by the soc-core when a sound
card is added. As these settings depend on the combination of codec and
cpu DAI, this should really be done by sound cards.
This patch removes fsl_ssi_setup() and adds the missing register setups
to fsl_ssi_set_dai_fmt(). It also removes all calls to fsl_ssi_setup().
Signed-off-by: Markus Pargmann <mpa at pengutronix.de>
---
sound/soc/fsl/fsl_ssi.c | 143 +++++++++++++-----------------------------------
1 file changed, 39 insertions(+), 104 deletions(-)
diff --git a/sound/soc/fsl/fsl_ssi.c b/sound/soc/fsl/fsl_ssi.c
index 5428a1f..144934e 100644
--- a/sound/soc/fsl/fsl_ssi.c
+++ b/sound/soc/fsl/fsl_ssi.c
@@ -642,96 +642,6 @@ static void fsl_ssi_setup_ac97(struct fsl_ssi_private *ssi_private)
write_ssi(CCSR_SSI_SOR_WAIT(3), &ssi->sor);
}
-static int fsl_ssi_setup(struct fsl_ssi_private *ssi_private)
-{
- struct ccsr_ssi __iomem *ssi = ssi_private->ssi;
- u8 wm;
- int synchronous = ssi_private->cpu_dai_drv.symmetric_rates;
-
- fsl_ssi_setup_reg_vals(ssi_private);
-
- if (ssi_private->imx_ac97)
- ssi_private->i2s_mode = CCSR_SSI_SCR_I2S_MODE_NORMAL | CCSR_SSI_SCR_NET;
- else
- ssi_private->i2s_mode = CCSR_SSI_SCR_I2S_MODE_SLAVE;
-
- /*
- * Section 16.5 of the MPC8610 reference manual says that the SSI needs
- * to be disabled before updating the registers we set here.
- */
- write_ssi_mask(&ssi->scr, CCSR_SSI_SCR_SSIEN, 0);
-
- /*
- * Program the SSI into I2S Slave Non-Network Synchronous mode. Also
- * enable the transmit and receive FIFO.
- *
- * FIXME: Little-endian samples require a different shift dir
- */
- write_ssi_mask(&ssi->scr,
- CCSR_SSI_SCR_I2S_MODE_MASK | CCSR_SSI_SCR_SYN,
- CCSR_SSI_SCR_TFR_CLK_DIS |
- ssi_private->i2s_mode |
- (synchronous ? CCSR_SSI_SCR_SYN : 0));
-
- write_ssi(CCSR_SSI_STCR_TXBIT0 | CCSR_SSI_STCR_TFSI |
- CCSR_SSI_STCR_TEFS | CCSR_SSI_STCR_TSCKP, &ssi->stcr);
-
- write_ssi(CCSR_SSI_SRCR_RXBIT0 | CCSR_SSI_SRCR_RFSI |
- CCSR_SSI_SRCR_REFS | CCSR_SSI_SRCR_RSCKP, &ssi->srcr);
-
- /*
- * The DC and PM bits are only used if the SSI is the clock master.
- */
-
- /*
- * Set the watermark for transmit FIFI 0 and receive FIFO 0. We don't
- * use FIFO 1. We program the transmit water to signal a DMA transfer
- * if there are only two (or fewer) elements left in the FIFO. Two
- * elements equals one frame (left channel, right channel). This value,
- * however, depends on the depth of the transmit buffer.
- *
- * We set the watermark on the same level as the DMA burstsize. For
- * fiq it is probably better to use the biggest possible watermark
- * size.
- */
- if (ssi_private->use_dma)
- wm = ssi_private->fifo_depth - 2;
- else
- wm = ssi_private->fifo_depth;
-
- write_ssi(CCSR_SSI_SFCSR_TFWM0(wm) | CCSR_SSI_SFCSR_RFWM0(wm) |
- CCSR_SSI_SFCSR_TFWM1(wm) | CCSR_SSI_SFCSR_RFWM1(wm),
- &ssi->sfcsr);
-
- /*
- * For ac97 interrupts are enabled with the startup of the substream
- * because it is also running without an active substream. Normally SSI
- * is only enabled when there is a substream.
- */
- if (ssi_private->imx_ac97)
- fsl_ssi_setup_ac97(ssi_private);
-
- /*
- * Set a default slot number so that there is no need for those common
- * cases like I2S mode to call the extra set_tdm_slot() any more.
- */
- if (!ssi_private->imx_ac97) {
- write_ssi_mask(&ssi->stccr, CCSR_SSI_SxCCR_DC_MASK,
- CCSR_SSI_SxCCR_DC(2));
- write_ssi_mask(&ssi->srccr, CCSR_SSI_SxCCR_DC_MASK,
- CCSR_SSI_SxCCR_DC(2));
- }
-
- if (ssi_private->use_dual_fifo) {
- write_ssi_mask(&ssi->srcr, 0, CCSR_SSI_SRCR_RFEN1);
- write_ssi_mask(&ssi->stcr, 0, CCSR_SSI_STCR_TFEN1);
- write_ssi_mask(&ssi->scr, 0, CCSR_SSI_SCR_TCH_EN);
- }
-
- return 0;
-}
-
-
/**
* fsl_ssi_startup: create a new substream
*
@@ -748,12 +658,7 @@ static int fsl_ssi_startup(struct snd_pcm_substream *substream,
snd_soc_dai_get_drvdata(rtd->cpu_dai);
unsigned long flags;
- /* First, we only do fsl_ssi_setup() when SSI is going to be active.
- * Second, fsl_ssi_setup was already called by ac97_init earlier if
- * the driver is in ac97 mode.
- */
if (!dai->active && !ssi_private->imx_ac97) {
- fsl_ssi_setup(ssi_private);
spin_lock_irqsave(&ssi_private->baudclk_lock, flags);
ssi_private->baudclk_locked = false;
spin_unlock_irqrestore(&ssi_private->baudclk_lock, flags);
@@ -835,6 +740,9 @@ static int fsl_ssi_set_dai_fmt(struct snd_soc_dai *cpu_dai, unsigned int fmt)
struct fsl_ssi_private *ssi_private = snd_soc_dai_get_drvdata(cpu_dai);
struct ccsr_ssi __iomem *ssi = ssi_private->ssi;
u32 strcr = 0, stcr, srcr, scr, mask;
+ u8 wm;
+
+ fsl_ssi_setup_reg_vals(ssi_private);
scr = read_ssi(&ssi->scr) & ~(CCSR_SSI_SCR_SYN | CCSR_SSI_SCR_I2S_MODE_MASK);
scr |= CCSR_SSI_SCR_NET;
@@ -857,7 +765,6 @@ static int fsl_ssi_set_dai_fmt(struct snd_soc_dai *cpu_dai, unsigned int fmt)
default:
return -EINVAL;
}
- scr |= ssi_private->i2s_mode;
/* Data on rising edge of bclk, frame low, 1clk before data */
strcr |= CCSR_SSI_STCR_TFSI | CCSR_SSI_STCR_TSCKP |
@@ -877,9 +784,13 @@ static int fsl_ssi_set_dai_fmt(struct snd_soc_dai *cpu_dai, unsigned int fmt)
strcr |= CCSR_SSI_STCR_TFSL | CCSR_SSI_STCR_TSCKP |
CCSR_SSI_STCR_TXBIT0;
break;
+ case SND_SOC_DAIFMT_AC97:
+ ssi_private->i2s_mode = CCSR_SSI_SCR_I2S_MODE_NORMAL;
+ break;
default:
return -EINVAL;
}
+ scr |= ssi_private->i2s_mode;
/* DAI clock inversion */
switch (fmt & SND_SOC_DAIFMT_INV_MASK) {
@@ -929,6 +840,38 @@ static int fsl_ssi_set_dai_fmt(struct snd_soc_dai *cpu_dai, unsigned int fmt)
write_ssi(srcr, &ssi->srcr);
write_ssi(scr, &ssi->scr);
+ /*
+ * Set the watermark for transmit FIFI 0 and receive FIFO 0. We don't
+ * use FIFO 1. We program the transmit water to signal a DMA transfer
+ * if there are only two (or fewer) elements left in the FIFO. Two
+ * elements equals one frame (left channel, right channel). This value,
+ * however, depends on the depth of the transmit buffer.
+ *
+ * We set the watermark on the same level as the DMA burstsize. For
+ * fiq it is probably better to use the biggest possible watermark
+ * size.
+ */
+ if (ssi_private->use_dma)
+ wm = ssi_private->fifo_depth - 2;
+ else
+ wm = ssi_private->fifo_depth;
+
+ write_ssi(CCSR_SSI_SFCSR_TFWM0(wm) | CCSR_SSI_SFCSR_RFWM0(wm) |
+ CCSR_SSI_SFCSR_TFWM1(wm) | CCSR_SSI_SFCSR_RFWM1(wm),
+ &ssi->sfcsr);
+
+ if (ssi_private->use_dual_fifo) {
+ write_ssi_mask(&ssi->srcr, CCSR_SSI_SRCR_RFEN1,
+ CCSR_SSI_SRCR_RFEN1);
+ write_ssi_mask(&ssi->stcr, CCSR_SSI_STCR_TFEN1,
+ CCSR_SSI_STCR_TFEN1);
+ write_ssi_mask(&ssi->scr, CCSR_SSI_SCR_TCH_EN,
+ CCSR_SSI_SCR_TCH_EN);
+ }
+
+ if (fmt & SND_SOC_DAIFMT_AC97)
+ fsl_ssi_setup_ac97(ssi_private);
+
return 0;
}
@@ -1184,11 +1127,6 @@ static struct snd_soc_dai_driver fsl_ssi_ac97_dai = {
static struct fsl_ssi_private *fsl_ac97_data;
-static void fsl_ssi_ac97_init(void)
-{
- fsl_ssi_setup(fsl_ac97_data);
-}
-
static void fsl_ssi_ac97_write(struct snd_ac97 *ac97, unsigned short reg,
unsigned short val)
{
@@ -1547,9 +1485,6 @@ static int fsl_ssi_probe(struct platform_device *pdev)
}
done:
- if (ssi_private->imx_ac97)
- fsl_ssi_ac97_init();
-
return 0;
error_dai:
--
1.9.0
More information about the linux-arm-kernel
mailing list