[PATCH v2 5/6] ARM: mvebu: Enable NAND controller in Armada 385-DB

[Sergei Shtylyov]

On 03/13/2014 10:39 PM, Ezequiel Garcia wrote:

> From: Ezequiel Garcia <ezequiel.garcia at free-electrons.com>

> The Armada 385-DB board has a NAND flash, so enable it in the
> devicetree and add the partitions as prepared in the factory images.

> Signed-off-by: Ezequiel Garcia <ezequiel.garcia at free-electrons.com>
> ---
>   arch/arm/boot/dts/armada-385-db.dts | 21 +++++++++++++++++++++
>   1 file changed, 21 insertions(+)

> diff --git a/arch/arm/boot/dts/armada-385-db.dts b/arch/arm/boot/dts/armada-385-db.dts
> index 9a13642..edcf7ff 100644
> --- a/arch/arm/boot/dts/armada-385-db.dts
> +++ b/arch/arm/boot/dts/armada-385-db.dts
> @@ -80,6 +80,27 @@
>   					reg = <1>;
>   				};
>   			};
> +
> +			flash: flash at d0000 {

    Note that you don't have to label your device the same way as it's named, 
i.e. you could have labelled it "nand" if it would make things clearer.
    Although I don't readily see the value of labeling nodes in the board's 
.dts file. Do you really expect to refer to it somewhere?

WBR, Sergei