[PATCH 0/7] ARM: dts: overo: Add new expansion boards

[Florian Vaussard]

Hi,

On 03/12/2014 06:22 PM, Tony Lindgren wrote:
> * Florian Vaussard <florian.vaussard at epfl.ch> [140311 05:24]:
>> Hi,
>>
>> This series adds the support for 5 new expansion boards from Gumstix:
>> - Palo43
>> - Gallop43
>> - Chestnut43
>> - Alto35
>> - Summit
>>
>> The 1st patch is a preparatory work, in order to factorize some
>> peripherals that are common to most Gumstix expansion boards. Patch 2
>> adds the support for an accelerometer that is present on most boards.
>>
>> Palo43, Gallop43 and Chestnut43 are all pretty similar. I tested
>> on a Gallop43 (with both OMAP35xx and OMAP36xx Overo).
>>
>> Alto35 is slightly different. Again, I tested with both OMAP35xx and
>> OMAP36xx Overo.
>>
>> Summit is pretty similar to Tobi. I do not have a Summit at hand,
>> but given the similarity with Tobi, it should work fine.
>>
>> To avoid unnecessary duplications, I put all the common stuff for each
>> board inside an omap3-overo-xxx-common.dsti include file. By doing so,
>> I can have minimal SoC-specific omap3-overo-xxx.dts (omap34xx based)
>> and omap3-overo-storm-xxx.dts (omap36xx based) device trees.
>>
>> This series depends on my previous Overo series [1]. A complete testing
>> tree (including the graphics support, soon to be posted) is available
>> at [2].
> 
> Thanks, applying the whole series into omap-for-v3.15/dt-overo.
> As it's this close to the merge window, no guarantees anything
> will get pulled in though.
> 

Thanks! Let's see. Anyway, this will not kill baby bears if it can't
make it into 3.15 :)

Regards,
Florian