[PATCH v4 1/5] mfd: add bcm590xx pmu DT binding

[Mark Rutland]

On Tue, Mar 11, 2014 at 11:33:53PM +0000, Matt Porter wrote:
> Add a DT binding for the BCM590xx PMUs. The binding inherits from
> the generic regulator bindings.
> 
> Signed-off-by: Matt Porter <mporter at linaro.org>
> Reviewed-by: Tim Kryger <tim.kryger at linaro.org>
> Reviewed-by: Markus Mayer <markus.mayer at linaro.org>
> ---
>  Documentation/devicetree/bindings/mfd/bcm590xx.txt | 41 ++++++++++++++++++++++
>  1 file changed, 41 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/mfd/bcm590xx.txt
> 
> diff --git a/Documentation/devicetree/bindings/mfd/bcm590xx.txt b/Documentation/devicetree/bindings/mfd/bcm590xx.txt
> new file mode 100644
> index 0000000..2300246
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/mfd/bcm590xx.txt
> @@ -0,0 +1,41 @@
> +-------------------------------
> +BCM590xx Power Management Units
> +-------------------------------
> +
> +Required properties:
> +- compatible: "brcm,bcm59056"
> +- reg: I2C slave address
> +- interrupts: interrupt for the PMU. Generic interrupt client node bindings
> +  are described in interrupt-controller/interrupts.txt

This all looks sane.

> +
> +------------------
> +Voltage Regulators
> +------------------
> +
> +Optional properties:
> +- regulators: This is the list of child nodes that specify the regulator
> +  initialization data for defined regulators.  Generic regulator bindings
> +  are described in regulator/regulator.txt.

This is a subnode, not a property. How about:

Optional child nodes:

- regulators: container node for regulators follwoing the generic
  regulator binding in regulator/regulator.txt.

> +
> +  The valid regulator nodes for BCM59056 are:

s/nodes/node names/

> +  	rfldo, camldo1, camldo2, simldo1, simldo2, sdldo, sdxldo,
> +	mmcldo1, mmcldo2, audldo, micldo, usbldo, vibldo,
> +	csr, iosr1, iosr2, msr, sdsr1, sdsr2, vsr
> +
> +Example:
> +	pmu: bcm59056 at 8 {
> +		compatible = "brcm,bcm59056";
> +		reg = <0x08>;
> +		interrupts = <GIC_SPI 215 IRQ_TYPE_LEVEL_HIGH>;
> +		regulators {
> +			#address-cells = <1>;
> +			#size-cells = <0>;
> +
> +			rfldo_reg: rfldo {
> +				regulator-min-microvolt = <1200000>;
> +				regulator-max-microvolt = <3300000>;

Are any specific properties required on these children?

Thanks,
Mark.

> +			};
> +
> +			...
> +		};
> +	};
> -- 
> 1.8.4
> 
>