[PATCH v2 7/7] ARM: zynq: DT: Migrate UART to Cadence binding

[Soren Brinkmann]

The Zynq UART is Cadence IP and the driver has been renamed accordingly.
Migrate the DT to use the new binding for the UART driver.

Signed-off-by: Soren Brinkmann <soren.brinkmann at xilinx.com>
Acked-by: Peter Crosthwaite <peter.crosthwaite at xilinx.com>
Acked-by: Rob Herring <robh at kernel.org>
---
This change depends on 'tty: xuartps: Rebrand driver as Cadence UART',
which introduces the new clock-names.
---
 arch/arm/boot/dts/zynq-7000.dtsi | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/arch/arm/boot/dts/zynq-7000.dtsi b/arch/arm/boot/dts/zynq-7000.dtsi
index 8b67b19392ec..0ed0d4b0579a 100644
--- a/arch/arm/boot/dts/zynq-7000.dtsi
+++ b/arch/arm/boot/dts/zynq-7000.dtsi
@@ -67,19 +67,19 @@
 		};
 
 		uart0: uart at e0000000 {
-			compatible = "xlnx,xuartps";
+			compatible = "xlnx,xuartps", "cdns,uart-r1p8";
 			status = "disabled";
 			clocks = <&clkc 23>, <&clkc 40>;
-			clock-names = "ref_clk", "aper_clk";
+			clock-names = "uart_clk", "pclk";
 			reg = <0xE0000000 0x1000>;
 			interrupts = <0 27 4>;
 		};
 
 		uart1: uart at e0001000 {
-			compatible = "xlnx,xuartps";
+			compatible = "xlnx,xuartps", "cdns,uart-r1p8";
 			status = "disabled";
 			clocks = <&clkc 24>, <&clkc 41>;
-			clock-names = "ref_clk", "aper_clk";
+			clock-names = "uart_clk", "pclk";
 			reg = <0xE0001000 0x1000>;
 			interrupts = <0 50 4>;
 		};
-- 
1.9.0.1.g4196000