[PATCH v3 3/8] phy: ti-pipe3: Add SATA compatible to Documentation binding

[Roger Quadros]

SATA PHY needs a new compatible ID. Add it to the DT binding documentation.

Acked-by: Kishon Vijay Abraham I <kishon at ti.com>
Signed-off-by: Roger Quadros <rogerq at ti.com>
---
 Documentation/devicetree/bindings/phy/ti-phy.txt | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/Documentation/devicetree/bindings/phy/ti-phy.txt b/Documentation/devicetree/bindings/phy/ti-phy.txt
index 96ba29e..4ab9cb1 100644
--- a/Documentation/devicetree/bindings/phy/ti-phy.txt
+++ b/Documentation/devicetree/bindings/phy/ti-phy.txt
@@ -53,7 +53,8 @@ usb2phy at 4a0ad080 {
 TI PIPE3 PHY
 
 Required properties:
- - compatible: Should be "ti,phy-usb3". "ti,omap-usb3" is deprecated.
+ - compatible: Should be "ti,phy-usb3" or "ti,phy-pipe3-sata".
+   "ti,omap-usb3" is deprecated.
  - reg : Address and length of the register set for the device.
  - reg-names: The names of the register addresses corresponding to the registers
    filled in "reg".
-- 
1.8.3.2