[PATCH v12 03/15] usb: phy-mxs: Add auto clock and power setting

[Peter Chen]

The auto setting is used to open related power and clocks
automatically after receiving wakeup signal.

With this feature, the PHY's clock and power can be recovered
correctly from low power mode, it is guaranteed by IC logic.

Signed-off-by: Peter Chen <peter.chen at freescale.com>
---
 drivers/usb/phy/phy-mxs-usb.c |   20 +++++++++++++++++---
 1 files changed, 17 insertions(+), 3 deletions(-)

diff --git a/drivers/usb/phy/phy-mxs-usb.c b/drivers/usb/phy/phy-mxs-usb.c
index cf58d8e..d7adca3 100644
--- a/drivers/usb/phy/phy-mxs-usb.c
+++ b/drivers/usb/phy/phy-mxs-usb.c
@@ -31,6 +31,11 @@
 
 #define BM_USBPHY_CTRL_SFTRST			BIT(31)
 #define BM_USBPHY_CTRL_CLKGATE			BIT(30)
+#define BM_USBPHY_CTRL_ENAUTOSET_USBCLKS	BIT(26)
+#define BM_USBPHY_CTRL_ENAUTOCLR_USBCLKGATE	BIT(25)
+#define BM_USBPHY_CTRL_ENAUTOCLR_PHY_PWD	BIT(20)
+#define BM_USBPHY_CTRL_ENAUTOCLR_CLKGATE	BIT(19)
+#define BM_USBPHY_CTRL_ENAUTO_PWRON_PLL		BIT(18)
 #define BM_USBPHY_CTRL_ENUTMILEVEL3		BIT(15)
 #define BM_USBPHY_CTRL_ENUTMILEVEL2		BIT(14)
 #define BM_USBPHY_CTRL_ENHOSTDISCONDETECT	BIT(1)
@@ -96,9 +101,18 @@ static int mxs_phy_hw_init(struct mxs_phy *mxs_phy)
 	/* Power up the PHY */
 	writel(0, base + HW_USBPHY_PWD);
 
-	/* enable FS/LS device */
-	writel(BM_USBPHY_CTRL_ENUTMILEVEL2 |
-	       BM_USBPHY_CTRL_ENUTMILEVEL3,
+	/*
+	 * USB PHY Ctrl Setting
+	 * - Auto clock/power on
+	 * - Enable full/low speed support
+	 */
+	writel(BM_USBPHY_CTRL_ENAUTOSET_USBCLKS |
+		BM_USBPHY_CTRL_ENAUTOCLR_USBCLKGATE |
+		BM_USBPHY_CTRL_ENAUTOCLR_PHY_PWD |
+		BM_USBPHY_CTRL_ENAUTOCLR_CLKGATE |
+		BM_USBPHY_CTRL_ENAUTO_PWRON_PLL |
+		BM_USBPHY_CTRL_ENUTMILEVEL2 |
+		BM_USBPHY_CTRL_ENUTMILEVEL3,
 	       base + HW_USBPHY_CTRL_SET);
 
 	return 0;
-- 
1.7.8