[PATCH v7 1/7] phy: add a driver for the Berlin SATA PHY

[Sergei Shtylyov]

Hello.

On 06/30/2014 07:44 PM, Antoine Ténart wrote:

>>>>> +	/* set the controller speed */
>>>>> +	writel(0x31, ctrl_reg + PORT_SCR_CTL);

>>>>     Value undocumented? Or is this the SATA SControl register by chance?

>>> Some magic is still there...

>> I guess Sergei was referring to AHCI spec here.

    Actually, even to the SATA specs. :-)

>> PORT_SCR bits are documented in AHCI spec as:

>> 7:4 = 0x3 Limit speed negotiation to a rate not greater than Gen3
>>            communication rate.

>> 3:0 = 0x1 Perform interface communication sequence [...]. This is
>>            functionally equivalent to a hard reset [...].

>> So, the question is: Should we really need to reset controller in the
>> PHY driver or is it already done in AHCI common code? At least we
>> should change the comment to something like
>> /* set Gen3 controller speed and perform hard reset */

> I just checked, the AHCI common code has a function to do the reset:
> ahci_reset_controller(). As of the max speed negociation rate, I did not
> see it in the common AHCI functions.

    You've looked in a wrong place -- since SControl is a standard *SATA* 
register, it gets read/written by the libata core. The low-level driver only 
provides scr_{read|write}() methods.

> The eSATA port on the Berlin2Q works without this line, but it may be a
> good idea to keep the max speed negociation rate.

    It's usually libata's task to negotiate the SATA speed.

> Anyway, we can remove the reset part. Nice catch!

    Thanks.

> Antoine

WBR, Sergei