[PATCH 0/1] ARM: dts: zynq: Prepare Parallella

[Andreas Färber]

Hello,

This patch adds an initial device tree for the Parallella board.
UART, SD card, Ethernet are enabled.
Not yet enabled are HDMI (FPGA, ADV7513), QSPI and 2x USB.

Where I'm a bit unsure is the PHY placement; placement as subnode of the 
GEM corresponds to what was in the downstream 3.12 based device tree. It 
is a separate chip on the board though, whereas GEM is on the SoC.

Regards,
Andreas

Andreas Färber (1):
  ARM: dts: zynq: Add Parallella device tree

 arch/arm/boot/dts/Makefile            |  4 ++-
 arch/arm/boot/dts/zynq-parallella.dts | 63 +++++++++++++++++++++++++++++++++++
 2 files changed, 66 insertions(+), 1 deletion(-)
 create mode 100644 arch/arm/boot/dts/zynq-parallella.dts

-- 
1.9.3