[PATCH V4 2/2] arm: dts: dra7: add crossbar device binding

[Tony Lindgren]

* Sricharan R <r.sricharan at ti.com> [140626 01:36]:
> Hi Tony,
> 
> On Thursday 26 June 2014 01:14 PM, Tony Lindgren wrote:
> > * Sricharan R <r.sricharan at ti.com> [140626 00:29]:
> >> From: R Sricharan <r.sricharan at ti.com>
> >>
> >> There is a IRQ crossbar device in the soc, which
> >> maps the irq requests from the peripherals to the
> >> mpu interrupt controller's inputs. The Peripheral irq
> >> requests are connected to only one crossbar
> >> input and the output of the crossbar is connected to only one
> >> controller's input line. The crossbar device is used to map
> >> a peripheral input to a free mpu's interrupt controller line.
> >>
> >> Here, adding a new crossbar device node and replacing all the peripheral
> >> interrupt numbers with its fixed crossbar input lines.
> > 
> > I think these two patches need to be a single patch to avoid
> > breaking booting for git bisect inbetween these patches?
>   This does not cause booting issues. irq_desc gets allocated linearly,
>    but that does not create boot issues.

OK

Tony