[PATCH v3 3/7] irqchip: atmel-aic: add new atmel AIC driver

[Jason Cooper]

Boris,

On Sun, Jun 22, 2014 at 10:56:54PM +0200, Boris BREZILLON wrote:
> 
> On 20/06/2014 17:01, Boris BREZILLON wrote:
> > Add new atmel AIC (Advanced Interrupt Controller) driver based on the
> > generic chip infrastructure.
> >
> > This driver is only compatible with dt enabled board and replaces the old
> > implementation found in arch/arm/mach-at91/irq.c.
> >
> > Signed-off-by: Boris BREZILLON <boris.brezillon at free-electrons.com>
> > ---
> >  drivers/irqchip/Kconfig         |   7 +
> >  drivers/irqchip/Makefile        |   1 +
> >  drivers/irqchip/irq-atmel-aic.c | 700 ++++++++++++++++++++++++++++++++++++++++
> >  3 files changed, 708 insertions(+)
> >  create mode 100644 drivers/irqchip/irq-atmel-aic.c
> >
> > diff --git a/drivers/irqchip/Kconfig b/drivers/irqchip/Kconfig
> > index bbb746e..6a7ad81 100644
> > --- a/drivers/irqchip/Kconfig
> > +++ b/drivers/irqchip/Kconfig
> > @@ -30,6 +30,13 @@ config ARM_VIC_NR
> >  	  The maximum number of VICs available in the system, for
> >  	  power management.
> >  
> 
> [...]
> 
> > +
> > +static int at91_aic_common_irq_domain_xlate(struct irq_domain *d,
> 
> This function should be named aic_common_irq_domain_xslate to be
> consistent with other function names.
> I'll fix that for the next version.

Other than this one change, this series looks good wrt to irqchip.  When
you respin, please adjust the patch subject lines like so:

  irqchip: atmel-aic: Add new atmel AIC driver

Note the capitalization.  Also, if you could add Thomas' Ack to the
first patch, that would be appreciated.

Once you post the new series, I assume it's ok to apply patches 1-3 to
irqchip/core, or are there some dependency considerations?

thx,

Jason.