[PATCH v2 02/12] Documentation: bindings: add reset bindings docs for Marvell Berlin SoCs

Antoine Ténart antoine.tenart at free-electrons.com
Tue Jun 24 03:35:11 PDT 2014


Add the reset binding documentation to the SoC binding documentation as
the reset driver in Marvell Berlin SoC is part of the chip/system
control registers. This patch adds the required properties to configure
the reset controller.

Signed-off-by: Antoine Ténart <antoine.tenart at free-electrons.com>
---
 Documentation/devicetree/bindings/arm/marvell,berlin.txt | 10 ++++++++++
 1 file changed, 10 insertions(+)

diff --git a/Documentation/devicetree/bindings/arm/marvell,berlin.txt b/Documentation/devicetree/bindings/arm/marvell,berlin.txt
index 94013a9a8769..32a1a8a652ad 100644
--- a/Documentation/devicetree/bindings/arm/marvell,berlin.txt
+++ b/Documentation/devicetree/bindings/arm/marvell,berlin.txt
@@ -90,11 +90,21 @@ Required subnode-properties:
 - groups: a list of strings describing the group names.
 - function: a string describing the function used to mux the groups.
 
+* Reset controller binding
+
+A reset controller is part of the chip control registers set. The chip control
+node also provides the reset. The register set is not at the same offset between
+Berlin SoCs.
+
+Required property:
+- #reset-cells: must be set to 2
+
 Example:
 
 chip: chip-control at ea0000 {
 	compatible = "marvell,berlin2-chip-ctrl";
 	#clock-cells = <1>;
+	#reset-cells = <2>;
 	reg = <0xea0000 0x400>;
 	clocks = <&refclk>, <&externaldev 0>;
 	clock-names = "refclk", "video_ext0";
-- 
1.9.1




More information about the linux-arm-kernel mailing list