[PATCH 06/29] ARM: shmobile: lager: Add VDD MPU regulator for DVFS

[Simon Horman]

From: Benoit Cousson <bcousson at baylibre.com>

The CA15 cluster is capable of voltage scaling. Add the regulator
in the i2c3 node, to allow the generic CPUFreq driver to use it.

Enable the i2c3 pin mux and the device node as well since the
da9210 is connected to that bus.

Note: In R-CAR Gen2, each frequency is using the same voltage,
and DVS control is not used. Therefore, this patch set the
voltage(Vmin/Vmax) to 1000mv.

Signed-off-by: Benoit Cousson <bcousson at baylibre.com>
[gaku.inami.xw at bp.renesas.com: Changes Vmin for disabling DVS]
Signed-off-by: Gaku Inami <gaku.inami.xw at bp.renesas.com>
Acked-by: Magnus Damm <damm at opensource.se>
Signed-off-by: Simon Horman <horms+renesas at verge.net.au>
---
 arch/arm/boot/dts/r8a7790-lager.dts | 21 +++++++++++++++++++++
 1 file changed, 21 insertions(+)

diff --git a/arch/arm/boot/dts/r8a7790-lager.dts b/arch/arm/boot/dts/r8a7790-lager.dts
index dd2fe46..6472cf0 100644
--- a/arch/arm/boot/dts/r8a7790-lager.dts
+++ b/arch/arm/boot/dts/r8a7790-lager.dts
@@ -204,6 +204,11 @@
 				 "msiof1_tx";
 		renesas,function = "msiof1";
 	};
+
+	i2c3_pins: i2c3 {
+		renesas,groups = "i2c3";
+		renesas,function = "i2c3";
+	};
 };
 
 &ether {
@@ -317,3 +322,19 @@
 	cd-gpios = <&gpio3 22 GPIO_ACTIVE_LOW>;
 	status = "okay";
 };
+
+&i2c3 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&i2c3_pins>;
+	status = "okay";
+
+	vdd_dvfs: regulator at 68 {
+		compatible = "diasemi,da9210";
+		reg = <0x68>;
+
+		regulator-min-microvolt = <1000000>;
+		regulator-max-microvolt = <1000000>;
+		regulator-boot-on;
+		regulator-always-on;
+	};
+};
-- 
2.0.0.rc2