[PATCH v2 4/7] ARM: at91/dt: split sama5d3 lcd pin definitions to match RGB mode configs

[Boris BREZILLON]

Hello Bo,

On 19/06/2014 09:07, Bo Shen wrote:
> Hi Boris,
>
> On 06/10/2014 12:04 AM, Boris BREZILLON wrote:
>> The HLCDC (High LCD Controller) IP supports 4 different output mode
>> (RGB444, RGB565, RGB666 and RGB888) and the pin muxing depends on the
>> chosen RGB mode.
>>
>> Split the pin definition to be able to set the pin config according
>> to the
>> selected mode.
>>
>> Signed-off-by: Boris BREZILLON <boris.brezillon at free-electrons.com>
>> ---
>>   arch/arm/boot/dts/sama5d3_lcd.dtsi | 127
>> ++++++++++++++++++++++++++++---------
>>   1 file changed, 96 insertions(+), 31 deletions(-)
>
> On sama5d3xek board, it only works in 24bits output mode. And it
> depends on the hardware design. So, I think only keep only one pinctrl
> configuration.

I'm not describing a specific board design but rather SoC capabilities
(this dtsi is SoC related not board related), and the sama5d3 SoC
supports 4 different RGB output modes through the RGB connector.

If you take a look at patch 7, you'll see that I chose mode 3 (which is
RGB888), and given this mode the HLCDC driver (atmel_hlcdc_panel.c) will
request the appropriate pin state:

atmel,panel = <&panel 3 0>;


Best Regards,

Boris

-- 
Boris Brezillon, Free Electrons
Embedded Linux and Kernel engineering
http://free-electrons.com