[PATCH v14 07/10] imx-drm: Use drm_display_mode timings flags.
Denis Carikli
denis at eukrea.com
Mon Jun 16 03:11:21 PDT 2014
The previous hardware behaviour was kept if the
flags are not set.
Signed-off-by: Denis Carikli <denis at eukrea.com>
---
ChangeLog v13->v14:
- Rebased
ChangeLog v12->v13:
- This patch doesn't need the DRM_MODE_FLAG_POL_*_PRESERVE flags anymore.
- code cleanup to improve readability:
- ENABLE_POL_PRESERVE is now gone
- Less modifications in ipu_di_init_sync_panel
- more readable modifications in int ipu_crtc_mode_set
ChangeLog v11->v12:
- Rebased: It now uses the following new flags defines names:
CLK_POL, ENABLE_POL
- The inversions in ipuv3-crtc.c are now fixed.
- ipuv3-crtc.c was still using mode->private_flags
from the previous versions of this patchset, that's now fixed.
ChangeLog v10->v11:
- This patch was splitted-out and adapted from:
"Prepare imx-drm for extra display-timings retrival."
- The display-timings dt specific part was removed.
- The flags names were changed to use the DRM ones from:
"drm: drm_display_mode: add signal polarity flags"
---
drivers/gpu/ipu-v3/ipu-di.c | 2 ++
drivers/staging/imx-drm/ipuv3-crtc.c | 18 ++++++++++++++++--
include/video/imx-ipu-v3.h | 4 ++--
3 files changed, 20 insertions(+), 4 deletions(-)
diff --git a/drivers/gpu/ipu-v3/ipu-di.c b/drivers/gpu/ipu-v3/ipu-di.c
index d00f357..1a1e116 100644
--- a/drivers/gpu/ipu-v3/ipu-di.c
+++ b/drivers/gpu/ipu-v3/ipu-di.c
@@ -597,6 +597,8 @@ int ipu_di_init_sync_panel(struct ipu_di *di, struct ipu_di_signal_cfg *sig)
if (sig->clk_pol == CLK_POL_POSEDGE)
di_gen |= DI_GEN_POLARITY_DISP_CLK;
+ else if (sig->clk_pol == CLK_POL_NEGEDGE)
+ di_gen &= ~DI_GEN_POLARITY_DISP_CLK;
ipu_di_write(di, di_gen, DI_GENERAL);
diff --git a/drivers/staging/imx-drm/ipuv3-crtc.c b/drivers/staging/imx-drm/ipuv3-crtc.c
index 7fec438..7fdf575 100644
--- a/drivers/staging/imx-drm/ipuv3-crtc.c
+++ b/drivers/staging/imx-drm/ipuv3-crtc.c
@@ -165,8 +165,22 @@ static int ipu_crtc_mode_set(struct drm_crtc *crtc,
if (mode->flags & DRM_MODE_FLAG_PVSYNC)
sig_cfg.Vsync_pol = 1;
- sig_cfg.enable_pol = ENABLE_POL_HIGH;
- sig_cfg.clk_pol = CLK_POL_NEGEDGE;
+ if (mode->pol_flags & DRM_MODE_FLAG_POL_PIXDATA_POSEDGE)
+ sig_cfg.clk_pol = CLK_POL_POSEDGE;
+ else if (mode->pol_flags & DRM_MODE_FLAG_POL_PIXDATA_NEGEDGE)
+ sig_cfg.clk_pol = CLK_POL_NEGEDGE;
+ else
+ /* If no PIXDATA flags were set, keep the old behaviour */
+ sig_cfg.clk_pol = CLK_POL_NEGEDGE;
+
+ if (mode->pol_flags & DRM_MODE_FLAG_POL_DE_HIGH)
+ sig_cfg.enable_pol = ENABLE_POL_HIGH;
+ else if (mode->pol_flags & DRM_MODE_FLAG_POL_DE_LOW)
+ sig_cfg.enable_pol = ENABLE_POL_LOW;
+ else
+ /* If no DE flags were set, keep the old behaviour */
+ sig_cfg.enable_pol = ENABLE_POL_HIGH;
+
sig_cfg.width = mode->hdisplay;
sig_cfg.height = mode->vdisplay;
sig_cfg.pixel_fmt = out_pixel_fmt;
diff --git a/include/video/imx-ipu-v3.h b/include/video/imx-ipu-v3.h
index 8888305..e660522 100644
--- a/include/video/imx-ipu-v3.h
+++ b/include/video/imx-ipu-v3.h
@@ -43,10 +43,10 @@ struct ipu_di_signal_cfg {
unsigned clksel_en:1;
unsigned clkidle_en:1;
unsigned data_pol:1; /* true = inverted */
- unsigned clk_pol:1;
- unsigned enable_pol:1;
unsigned Hsync_pol:1; /* true = active high */
unsigned Vsync_pol:1;
+ u8 clk_pol;
+ u8 enable_pol;
u16 width;
u16 height;
--
1.7.9.5
More information about the linux-arm-kernel
mailing list