[PATCH 1/2] ARM: tegra: tamonten: add the base board regulators

[Stephen Warren]

On 06/12/2014 09:11 AM, Alban Bedel wrote:
> Currently the Tamonten DTS define a fixed regulator for the 5V supply.
> However this regulator is in fact on the base board. Fix this by
> properly defining the regulators found on the base boards.

> diff --git a/arch/arm/boot/dts/tegra20-medcom-wide.dts b/arch/arm/boot/dts/tegra20-medcom-wide.dts

> +	board_regulators {

The name "board_regulators" encodes both type ("regulators") and
identify ("board": the regulators on the board). DT node names are
suposed to contain type but not identity information.

The way this is done in other Tegra DTs is to have a regulators node in
both the board and module DT files, and use different ranges of reg
values for the board and module; e.g. 0..99 for module and 100.. for the
board or similar.

Other than that, this patch looks fine.