[PATCH 2/4] usb: host: xhci-plat: Add support to get PHYs

[Julius Werner]

> diff --git a/drivers/usb/host/xhci.h b/drivers/usb/host/xhci.h
> index 9ffecd5..453d89e 100644
> --- a/drivers/usb/host/xhci.h
> +++ b/drivers/usb/host/xhci.h
> @@ -1582,6 +1582,9 @@ struct xhci_hcd {
>         u32                     port_status_u0;
>  /* Compliance Mode Timer Triggered every 2 seconds */
>  #define COMP_MODE_RCVRY_MSECS 2000
> +       /* phys for the controller */
> +       struct phy              *phy2_gen;
> +       struct phy              *phy3_gen;
>  };

I don't think adding new variables here and restricting most of this
logic to xhci-plat.c (in the next patch) is the best way to do it.
There's no conceptual reason why other host controllers (e.g. xhci-pci
or even EHCI) could not have a similar need to tune their PHY after
reset. PHYs are universal to all host controllers.

There is already a 'phy' member in struct usb_hcd which I think is
mostly unused right now. I think it would be much less
confusing/redundant to reuse that member for this purpose (you could
still set it up from xhci_plat_probe(), and then call it from
hcd_bus_resume() or something like that). Since XHCI host controllers
already conveniently have two struct usb_hcd (one for 2.0 and one for
3.0), you can cleanly store references to your two PHYs in there.