[PATCH 4/4] ARM: dts: rockchip: add rk3188 dma controllers

[Sergei Shtylyov]

Hello.

On 07/29/2014 11:12 PM, Heiko Stuebner wrote:

> Add both the cpu and peripheral pl330 dma controllers present in rk3188 socs.
> The first dma controller can change between secure and non-secure mode and is
> left by the bootloader in secure mode, which gets added here.

> Signed-off-by: Heiko Stuebner <heiko at sntech.de>
> ---
>   arch/arm/boot/dts/rk3xxx.dtsi | 27 +++++++++++++++++++++++++++
>   1 file changed, 27 insertions(+)

> diff --git a/arch/arm/boot/dts/rk3xxx.dtsi b/arch/arm/boot/dts/rk3xxx.dtsi
> index c6f0561..a6c2860 100644
> --- a/arch/arm/boot/dts/rk3xxx.dtsi
> +++ b/arch/arm/boot/dts/rk3xxx.dtsi
> @@ -28,6 +28,33 @@
>   		i2c4 = &i2c4;
>   	};
>
> +	amba {
> +		compatible = "arm,amba-bus";
> +		#address-cells = <1>;
> +		#size-cells = <1>;
> +		ranges;
> +
> +		dmac1: dma at 20018000 {

    The ePAPR standard [1] says:

The name of a node should be somewhat generic, reflecting the function of the 
device and not its precise programming model. If appropriate, the name should 
be one of the following choices:

[...]
    • dma-controller

> +			compatible = "arm,pl330", "arm,primecell";
> +			reg = <0x20018000 0x4000>;
> +			interrupts = <GIC_SPI 0 IRQ_TYPE_LEVEL_HIGH>,
> +				     <GIC_SPI 1 IRQ_TYPE_LEVEL_HIGH>;
> +			#dma-cells = <1>;
> +			clocks = <&cru ACLK_DMA1>;
> +			clock-names = "apb_pclk";
> +		};
[...]

[1] http://www.power.org/resources/downloads/Power_ePAPR_APPROVED_v1.0.pdf

WBR, Sergei