[PATCH 19/19] Documentation: ACPI for ARM64

[Christoffer Dall]

On 29 July 2014 16:41, Arnd Bergmann <arnd at arndb.de> wrote:
> On Tuesday 29 July 2014 15:31:16 Christoffer Dall wrote:
>> On 29 July 2014 15:08, Mark Rutland <mark.rutland at arm.com> wrote:
>> > On Tue, Jul 29, 2014 at 01:52:40PM +0100, Arnd Bergmann wrote:
>> >> On Tuesday 29 July 2014 14:37:38 Christoffer Dall wrote:
>> >> >
>> >> > For reference, Red Hat's current arguing point for ACPI in VMs is
>> >> > hotplug of things like CPUs and memory for very large VMs, but I
>> >> > haven't thought too carefully about this just yet, as I don't have a
>> >> > 100+ core ARM 64-bit hardware lying around...
>> >>
>> >> I thought you could run guests with more virtual CPUs that you have
>> >> physical CPUs on the host.
>> >>
>> >> Regarding CPU and memory hotplug, don't we already have PSCI and
>> >> xen-balloon/virtio-balloon for that?
>> >
>> > PSCI (0.1) was there for guests from the start, and ACPI doesn't do
>> > anything different w.r.t. PSCI other than requiring PSCI 0.2 (which can
>> > be used by guests supporting only PSCI 0.1). So there's no magic for
>> > CPU hotplug provided by ACPI.
>>
>> With PSCI you can only provide your VM a bunch of CPUs and say that
>> they're all turned off, and then turn some of them on later.  I
>> honestly don't know if you can do proper CPU hotplug with ACPI, but
>> the RH guys seem to argue that you can.  Again, I didn't think too
>> carefully about this.
>
> Xen does this in drivers/xen/cpu_hotplug.c, acpi does it in
> drivers/acpi/acpi_processor.c.
>
>> > Do either of the balloon drivers allow for memory to be hot-added to a
>> > system initially provisioned with less?
>> >
>> No, it's just about reclaiming memory.  Same argument as above.
>
> Again, Xen seems to be able to add more memory:
>
> config XEN_BALLOON_MEMORY_HOTPLUG
>         bool "Memory hotplug support for Xen balloon driver"
>         default n
>         depends on XEN_BALLOON && MEMORY_HOTPLUG
>         help
>           Memory hotplug support for Xen balloon driver allows expanding memory
>           available for the system above limit declared at system startup.
>           It is very useful on critical systems which require long
>           run without rebooting.
>           ...
>
> The same goes for hyperv, s390 and vmware. It should not be hard to add it
> for KVM.
>
Absolutely, and I would prefer doing that over adding ACPI in guests
as things stand right now.  We can have another fun discussion about
this at LCU...

-Christoffer