[PATCH 0/6] vf610: Add USB support

[Stefan Agner]

Am 2014-07-22 02:13, schrieb Peter Chen:
> On Fri, Jul 18, 2014 at 07:01:36PM +0200, Stefan Agner wrote:
>> This patchset adds USB support for Vybrid VF610 SoC. It extends the
>> clock framework to support the USB PHY cocks, extends the device
>> tree files and adds support for the non-core registers in the
>> usbmisc_imx driver.
>>
>> This patchset needs the eSDHC length fix available in Shawn's
>> for-next branch.
>>
> 
> Why it is related to USB patchset?
> 

The eSDHC registers are just in front of the USB registers. Due to the
wrong length, the two register areas overlapped, hence the second driver
(and I think it was USB which was loaded second) could not probe
successfully.

>> The whole patchset proved to be working on a Colibri VF61. The
>> first USB controller runs in peripheral mode. I could successfully
>> use RNDIS, however with some stability issues: Suddenly the other
>> side was not reachable anymore and the interface needed to brought
>> down and back up again. I'm still investigating this.
> 
> Do you use ubuntu as host distribution? I find ubuntu will lost the
> first connection for usb-ethernet-gadget(usb0) as network interface,
> but once you re-config usb0 again (ifconfig usb0 ip up), it should work
> and will not lose connection any more.
> 

I use a Angstrom build, an OpenEmbedded distribution. I restarted the
link using ip link set dev usb0 up/down, this brought the link back in a
pingable state, however even afterwards after some seconds of iperf, the
link hanged again...

--
Stefan