[PATCH 1/3] ARM: dts: Add DT changes for display on snow
Ajay Kumar
ajaykumar.rs at samsung.com
Fri Jul 25 12:44:22 PDT 2014
Add DT nodes for ptn3460 bridge chip and panel-simple panel.
Add backlight enable pin and backlight power supply for pwm-backlight.
Also add bridge phandle needed by dp to enable display on snow.
Signed-off-by: Ajay Kumar <ajaykumar.rs at samsung.com>
---
arch/arm/boot/dts/exynos5250-snow.dts | 40 +++++++++++++++++----------------
1 file changed, 21 insertions(+), 19 deletions(-)
diff --git a/arch/arm/boot/dts/exynos5250-snow.dts b/arch/arm/boot/dts/exynos5250-snow.dts
index 6c36d41..f57f993 100644
--- a/arch/arm/boot/dts/exynos5250-snow.dts
+++ b/arch/arm/boot/dts/exynos5250-snow.dts
@@ -270,7 +270,7 @@
dcdc3 {
ti,enable-ext-control;
};
- fet1 {
+ fet1: fet1 {
regulator-name = "vcd_led";
ti,overcurrent-wait = <3>;
};
@@ -293,7 +293,7 @@
regulator-always-on;
ti,overcurrent-wait = <3>;
};
- fet6 {
+ fet6: fet6 {
regulator-name = "lcd_vdd";
ti,overcurrent-wait = <3>;
};
@@ -342,6 +342,15 @@
pinctrl-0 = <&max98095_en>;
pinctrl-names = "default";
};
+
+ ptn3460: ptn3460-bridge at 20 {
+ compatible = "nxp,ptn3460";
+ reg = <0x20>;
+ powerdown-gpios = <&gpy2 5 0>;
+ reset-gpios = <&gpx1 5 0>;
+ edid-emulation = <5>;
+ panel = <&panel>;
+ };
};
i2s0: i2s at 03830000 {
@@ -389,11 +398,13 @@
vdd_pll-supply = <&ldo8_reg>;
};
- backlight {
+ backlight: backlight {
compatible = "pwm-backlight";
pwms = <&pwm 0 1000000 0>;
brightness-levels = <0 100 500 1000 1500 2000 2500 2800>;
default-brightness-level = <7>;
+ enable-gpios = <&gpx3 0 0>;
+ power-supply = <&fet1>;
pinctrl-0 = <&pwm0_out>;
pinctrl-names = "default";
};
@@ -403,6 +414,12 @@
samsung,invert-vclk;
};
+ panel: panel-simple {
+ compatible = "simple-panel";
+ power-supply = <&fet6>;
+ backlight = <&backlight>;
+ };
+
dp-controller at 145B0000 {
status = "okay";
pinctrl-names = "default";
@@ -414,21 +431,6 @@
samsung,link-rate = <0x0a>;
samsung,lane-count = <2>;
samsung,hpd-gpio = <&gpx0 7 0>;
-
- display-timings {
- native-mode = <&timing1>;
-
- timing1: timing at 1 {
- clock-frequency = <70589280>;
- hactive = <1366>;
- vactive = <768>;
- hfront-porch = <40>;
- hback-porch = <40>;
- hsync-len = <32>;
- vback-porch = <10>;
- vfront-porch = <12>;
- vsync-len = <6>;
- };
- };
+ bridge = <&ptn3460>;
};
};
--
1.7.9.5
More information about the linux-arm-kernel
mailing list