[PATCH v3 07/12] usb: chipidea: add a usb2 driver for ci13xxx

[Peter Chen]

> 
> On Fri, Jul 25, 2014 at 10:18:54AM +0800, Peter Chen wrote:
> > On Wed, Jul 16, 2014 at 10:26:01AM +0200, Antoine Ténart wrote:
> > > Add a USB2 ChipIdea driver for ci13xxx, with optional PHY, clock and
> > > DMA mask, to support USB2 ChipIdea controllers that don't need
> > > specific functions.
> >
> > You may need to indicate it is a generic usb2 glue layer driver at
> > both subject and context.
> 
> "USB2 ChipIdea driver for ci13xxx" seemed quite generic to me.
> 

ok

> > >
> > > Needed for the Marvell Berlin SoCs USB controllers.
> >
> > You can say it is tested at Marvell Berlin SoCs USB controllers.
> 
> Ok, I'll explicitly say it.
> 
> > > +
> > > +static int ci_hdrc_usb2_dt_probe(struct device *dev,
> > > +				    struct ci_hdrc_platform_data *ci_pdata,
> > > +				    struct ci_hdrc_usb2_priv *priv) {
> > > +	u32 mask;
> > > +	int ret;
> > > +
> > > +	priv->clk = devm_clk_get(dev, NULL);
> > > +	if (!IS_ERR(priv->clk)) {
> > > +		ret = clk_prepare_enable(priv->clk);
> > > +		if (ret) {
> > > +			dev_err(dev, "failed to enable the clock: %d\n", ret);
> > > +			return ret;
> > > +		}
> > > +	}
> >
> > The clk API may be needed for both DT and non-DT cases.
> 
> Yes sure, I'll move this to the ci_hdrc_usb2_probe().
> 
 
> > > +
> > > +	if (of_property_read_u32(dev->of_node, "dma-mask", &mask))
> > > +		priv->dma_mask = mask;
> > > +
> > According to discussion, you may not need dma_mask in driver any more,
> > and use below API for both DT and non-DT case.
> >
> >         err = dma_set_mask_and_coherent(&pdev->dev, DMA_BIT_MASK(32));
> >         if (err)
> >         	                handle error;
> 
> This would only be needed in non-dt cases, as the DMA mask is configured
> in drivers/of/platform.c otherwise.
> 
 
Get it, thanks.

Peter