[PATCH v3 1/2] ARM: at91/dt: describe rgmii ethernet phy connected to sama5d3xek boards

[Florian Fainelli]

2014-07-18 7:21 GMT-07:00 Nicolas Ferre <nicolas.ferre at atmel.com>:
> On 10/07/2014 21:59, Boris BREZILLON :
>> Add ethernet-phy nodes and specify phy interrupt (connected to pin PB25)
>> and board specific timing configs.
>>
>> Atmel has two different HW designs for its CPU modules: the first one
>> (produced by Embest) is connecting PHYAD[0-2] pins to pull up resistors
>> and the other one (produced by Ronetix) is connecting PHYAD0 to a pull up
>> resistor and PHYAD[1-2] to pull down resistors.
>> As a result, Ronetix design will have its PHY available at address 0x1 and
>> Embest design at 0x7.
>> By defining both phys we're letting the phy core detect the one actually
>> available on the MDIO bus.
>>
>> Signed-off-by: Boris BREZILLON <boris.brezillon at free-electrons.com>
>> ---
>>
>> Florian, I dropped your Reviewed-by tag because this patch has slightly
>> changed.
>
> Hi Florian,
>
> I would like to have your Ack on this one as we discussed this solution
> with you.

Acked-by: Florian Fainelli <f.fainelli at gmail.com>

>
> Thanks, bye,
>
>
>>  arch/arm/boot/dts/sama5d3xcm.dtsi | 30 ++++++++++++++++++++++++++++++
>>  1 file changed, 30 insertions(+)
>>
>> diff --git a/arch/arm/boot/dts/sama5d3xcm.dtsi b/arch/arm/boot/dts/sama5d3xcm.dtsi
>> index b0b1331..755369e 100644
>> --- a/arch/arm/boot/dts/sama5d3xcm.dtsi
>> +++ b/arch/arm/boot/dts/sama5d3xcm.dtsi
>> @@ -34,6 +34,36 @@
>>
>>                       macb0: ethernet at f0028000 {
>>                               phy-mode = "rgmii";
>> +                             #address-cells = <1>;
>> +                             #size-cells = <0>;
>> +
>> +                             ethernet-phy at 1 {
>> +                                     reg = <0x1>;
>> +                                     interrupt-parent = <&pioB>;
>> +                                     interrupts = <25 IRQ_TYPE_EDGE_FALLING>;
>> +                                     txen-skew-ps = <800>;
>> +                                     txc-skew-ps = <3000>;
>> +                                     rxdv-skew-ps = <400>;
>> +                                     rxc-skew-ps = <3000>;
>> +                                     rxd0-skew-ps = <400>;
>> +                                     rxd1-skew-ps = <400>;
>> +                                     rxd2-skew-ps = <400>;
>> +                                     rxd3-skew-ps = <400>;
>> +                             };
>> +
>> +                             ethernet-phy at 7 {
>> +                                     reg = <0x7>;
>> +                                     interrupt-parent = <&pioB>;
>> +                                     interrupts = <25 IRQ_TYPE_EDGE_FALLING>;
>> +                                     txen-skew-ps = <800>;
>> +                                     txc-skew-ps = <3000>;
>> +                                     rxdv-skew-ps = <400>;
>> +                                     rxc-skew-ps = <3000>;
>> +                                     rxd0-skew-ps = <400>;
>> +                                     rxd1-skew-ps = <400>;
>> +                                     rxd2-skew-ps = <400>;
>> +                                     rxd3-skew-ps = <400>;
>> +                             };
>>                       };
>>
>>                       pmc: pmc at fffffc00 {
>>
>
>
> --
> Nicolas Ferre



-- 
Florian