[PATCH v3 05/12] phy: add the Berlin USB PHY driver

[Varka Bhadram]

On 07/16/2014 02:55 PM, Antoine Ténart wrote:
> Hi Varka,
>
> On Wed, Jul 16, 2014 at 02:49:05PM +0530, Varka Bhadram wrote:
>> On 07/16/2014 01:55 PM, Antoine Ténart wrote:
>>> +static const struct of_device_id phy_berlin_sata_of_match[] = {
>>> +	{
>>> +		.compatible = "marvell,berlin2-usb-phy",
>>> +		.data = &phy_berlin_pll_dividers[0],
>>> +	},
>>> +	{
>>> +		.compatible = "marvell,berlin2cd-usb-phy",
>>> +		.data = &phy_berlin_pll_dividers[1],
>>> +	},
>>> +	{ },
>>> +};
>>> +MODULE_DEVICE_TABLE(of, phy_berlin_sata_of_match);
>>> +
>> It looks good if we move this after probe().. So that we can see of_match_table directly...
> We use the of match table in the probe, when calling of_match_device().
>
>>> +static int phy_berlin_usb_probe(struct platform_device *pdev)
>>> +{
>>> +	const struct of_device_id *match =
>>> +		of_match_device(phy_berlin_sata_of_match, &pdev->dev);

We are updating of_match_table in platform_driver struct.

Every driver follows the concept of giving the of_device_ids
above the platform_driver declaration...

> Here.
>
> Antoine
>