[PATCH v3 08/12] Documentation: bindings: add doc for the USB2 ChipIdea USB driver

[Arnd Bergmann]

On Wednesday 16 July 2014 10:26:02 Antoine Ténart wrote:
> +
> +Required properties:
> +- compatible: should be "chipidea,usb2"
> +- reg: base address and length of the registers
> +- interrupts: interrupt for the USB controller
> +
> +Optional properties:
> +- clocks: reference to the USB clock
> +- usb-phy: reference to the USB PHY

I think the phy reference should use the standard phy binding, using
"phys" property to refer to a node that has a "#phy-cells" property.

It seems the code gets this right, but just the documentation is wrong.

> +- vbus-supply: reference to the VBUS regulator
> +- dma-mask: DMA bit mask

No. Do not use "dma-mask" as a property, that is a pure Linux specific
concept. The DT way to express this is to use the 'dma-ranges' property
in the device's parent to describe any bus-related restrictions, and
for the driver to ask for a mask that matches what the hardware is
capable of (which may be smaller or larger than what the bus supports).

	Arnd