[PATCH v7 0/4] arm: Fix DEBUG_LL for multi-platform kernels (without PL01X)

[Daniel Thompson]

On 15/07/14 11:32, Arnd Bergmann wrote:
> On Monday 14 July 2014 17:27:49 Arnd Bergmann wrote:
>>
>> Signed-off-by: Arnd Bergmann <arnd at arndb.de>
>>
>> diff --git a/arch/arm/Kconfig.debug b/arch/arm/Kconfig.debug
>> index 8f90595069a1..0f89d1b84524 100644
>> --- a/arch/arm/Kconfig.debug
>> +++ b/arch/arm/Kconfig.debug
>> @@ -200,6 +200,14 @@ choice
>>  		  Say Y here if you want the debug print routines to direct
>>  		  their output to the serial port in the DC21285 (Footbridge).
>>  
>> +	config DEBUG_EP93XX
>> +		bool "Kernel low-level debugging messages via ep93xx UART"
>> +		depends on ARCH_EP93XX
>> +		select DEBUG_UART_PL01X
>> +		help
>> +		  Say Y here if you want kernel low-level debugging support
>> +		  on Cirrus Logic EP93xx based platforms.
>> +
> 
> FWIW, this part was broken, fixup below. The problem is that the decompress.h
> for ep93xx uses CONFIG_DEBUG_UART_PHYS even when DEBUG_LL is disabled.

Thanks (this fix is already in my patchset but your proposal means it
needs changing slightly).


> diff --git a/arch/arm/Kconfig.debug b/arch/arm/Kconfig.debug
> index 362d764cd358..a99b28029983 100644
> --- a/arch/arm/Kconfig.debug
> +++ b/arch/arm/Kconfig.debug
> @@ -1139,7 +1139,7 @@ config DEBUG_UART_PHYS
>  	default 0x80070000 if DEBUG_IMX23_UART
>  	default 0x80074000 if DEBUG_IMX28_UART
>  	default 0x80230000 if DEBUG_PICOXCELL_UART
> -	default 0x808c0000 if DEBUG_EP93XX
> +	default 0x808c0000 if DEBUG_EP93XX || ARCH_EP93XX
>  	default 0x90020000 if DEBUG_NSPIRE_CLASSIC_UART || DEBUG_NSPIRE_CX_UART
>  	default 0xa9a00000 if DEBUG_MSM_UART
>  	default 0xb0090000 if DEBUG_VEXPRESS_UART0_CRX
> @@ -1166,7 +1166,8 @@ config DEBUG_UART_PHYS
>  	depends on DEBUG_LL_UART_8250 || DEBUG_LL_UART_PL01X || \
>  		DEBUG_LL_UART_EFM32 || \
>  		DEBUG_UART_8250 || DEBUG_UART_PL01X || \
> -		DEBUG_MSM_UART || DEBUG_QCOM_UARTDM || DEBUG_S3C24XX_UART
> +		DEBUG_MSM_UART || DEBUG_QCOM_UARTDM || DEBUG_S3C24XX_UART || \
> +		ARCH_EP93XX
>  
>  config DEBUG_UART_VIRT
>  	hex "Virtual base address of debug UART"
>