[alsa-devel] [PATCH 2/4] ASoC: s3c64xx/smartq: use dynamic registration

[Arnd Bergmann]

On Monday 14 July 2014 18:18:12 Lars-Peter Clausen wrote:
> On 07/14/2014 05:46 PM, Arnd Bergmann wrote:
> [...]
> >>> +static struct gpiod_lookup_table smartq_audio_gpios = {
> >>> +   .dev_id = "smartq-audio",
> >>> +   .table = {
> >>> +           GPIO_LOOKUP("GPL", 12, "headphone detect", 0),
> >>> +           GPIO_LOOKUP("GPK", 12, "amplifiers shutdown", GPIO_ACTIVE_HIGH),
> >>
> >> There is no such thing as GPIO_ACTIVE_HIGH, just 0 for flags.
> >
> > The original driver does gpio_direction_output(..., 1);
> >
> > For some reason I earlier concluded that this was what the '1' would need
> > to get converted to. Are you sure '0' is correct then?
> >
> 
> Yes. But now that you say it the gpiod_direction_output() call is missing 
> from this patch.

I'm lost now. The GPIO_ACTIVE_HIGH I added comes from Documentation/gpio/board.txt
and as Linus Walleij explained to me the other day, the lookup is supposed
to replace devm_gpio_request_one(), which in turn replaced both the
gpio_request and the gpio_direction_output(). Do I need to put the
gpiod_direction_output() back or is there another interface for that when
registering the board gpios?

	Arnd