[PATCH 5/8] of: Add Tegra124 EMC bindings

[Mikko Perttunen]

On 11/07/14 19:01, Mikko Perttunen wrote:
> On 07/11/2014 05:51 PM, Thierry Reding wrote:
>> On Fri, Jul 11, 2014 at 05:18:30PM +0300, Mikko Perttunen wrote:
>>> ...
>> ...
>
> In this case, all the registers that will be written are such that the
> MC driver will never need to write them. They are shadowed registers,
> meaning that all writes are stored and are only effective starting from
> the next time the EMC rate change state machine is activated, so writing
> them from anywhere except than the EMC driver would be pointless.
>
> I can find two users of these registers in downstream:
> 1) mc.c saves and loads them on suspend/restore (I don't know why, that
> shouldn't do anything. They will be overridden anyway during the next
> EMC rate change).
> 2) tegra12x_la.c reads MC_EMEM_ARB_MISC0 during a core_initcall to
> calculate a value which it then writes to a register that is also
> shadowed and that is part of downstream burst registers so that doesn't
> do anything either.
>
> The reason I implemented two ways to specify the MC register area was
> that this could be merged before an MC driver and retain
> backwards-compatibility after the MC driver arrives.
>
> If this is not acceptable, we can certainly wait for the MC driver to be
> merged first. (Although with the general rate of things, I hope I won't
> be back at school at that point..) I assume that this is blocked on the
> IOMMU bindings discussion? In that case, there are several options: the
> MC driver could have its own tables for each EMC rate or we could just
> make the EMC tables global (i.e. not under the EMC node). In any case,
> the MC driver would need to implement a function that would just write
> these values but be guaranteed to not do anything else, since that could
> cause nasty things during the EMC rate change sequence.

Having taken another look at the code, I don't think the MC driver could 
do anything that bad. There are also two other places where the EMC 
driver needs to read MC registers: Inside the sequence, it reads a 
register but discards its contents. According to comments, this acts as 
a memory barrier, probably for the preceding step that writes into MC 
memory. If the register writes are moved to the MC driver, it could also 
handle that. In another place it reads the number of RAM modules from a 
MC register. The MC driver could export this as another function.

That said, I still suspect it might not be worth it to divide this 
between two drivers.

- Mikko