[PATCH 3/4] mmc: sdhci: add quirk for single block transactions

[Vincent Yang]

This patch defines a quirk to disable the block count
for single block transactions.
It is a preparation and will be used by Fujitsu
SDHCI controller f_sdh30 driver.

Signed-off-by: Vincent Yang <Vincent.Yang at tw.fujitsu.com>
---
 drivers/mmc/host/sdhci.c  | 8 +++++---
 include/linux/mmc/sdhci.h | 2 ++
 2 files changed, 7 insertions(+), 3 deletions(-)

diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c
index 900b4e4..169e17d 100644
--- a/drivers/mmc/host/sdhci.c
+++ b/drivers/mmc/host/sdhci.c
@@ -876,7 +876,7 @@ static void sdhci_prepare_data(struct sdhci_host *host, struct mmc_command *cmd)
 static void sdhci_set_transfer_mode(struct sdhci_host *host,
 	struct mmc_command *cmd)
 {
-	u16 mode;
+	u16 mode = 0;
 	struct mmc_data *data = cmd->data;
 
 	if (data == NULL) {
@@ -889,9 +889,11 @@ static void sdhci_set_transfer_mode(struct sdhci_host *host,
 
 	WARN_ON(!host->data);
 
-	mode = SDHCI_TRNS_BLK_CNT_EN;
+	if (!(host->quirks2 & SDHCI_QUIRK2_SUPPORT_SINGLE))
+		mode = SDHCI_TRNS_BLK_CNT_EN;
+
 	if (mmc_op_multi(cmd->opcode) || data->blocks > 1) {
-		mode |= SDHCI_TRNS_MULTI;
+		mode = SDHCI_TRNS_BLK_CNT_EN | SDHCI_TRNS_MULTI;
 		/*
 		 * If we are sending CMD23, CMD12 never gets sent
 		 * on successful completion (so no Auto-CMD12).
diff --git a/include/linux/mmc/sdhci.h b/include/linux/mmc/sdhci.h
index bcbad45..72072d1 100644
--- a/include/linux/mmc/sdhci.h
+++ b/include/linux/mmc/sdhci.h
@@ -102,6 +102,8 @@ struct sdhci_host {
 #define SDHCI_QUIRK2_VOLTAGE_SWITCH			(1<<8)
 /* forced tuned clock */
 #define SDHCI_QUIRK2_TUNING_WORK_AROUND		(1<<9)
+/* disable the block count for single block transactions */
+#define SDHCI_QUIRK2_SUPPORT_SINGLE			(1<<10)
 
 	int irq;		/* Device IRQ */
 	void __iomem *ioaddr;	/* Mapped address */
-- 
1.9.0