[PATCH v4 02/10] mmc: sdhci-st: ST Microelectronics SDHCI binding documentation.

[Ulf Hansson]

On 9 July 2014 17:07, Peter Griffin <peter.griffin at linaro.org> wrote:
> This patch adds the device tree binding documentation for the ST
> SDHCI driver. It documents the differences between the core properties
> described by mmc.txt and the properties used by the sdhci-st driver.
>
> Signed-off-by: Giuseppe Cavallaro <peppe.cavallaro at st.com>
> Signed-off-by: Peter Griffin <peter.griffin at linaro.org>
> Acked-by: Lee Jones <lee.jones at linaro.org>
> Acked-by: Maxime Coquelin <maxime.coquelin at st.com>

Thanks! Applied for next.

Kind regards
Uffe

> ---
>  Documentation/devicetree/bindings/mmc/sdhci-st.txt | 33 ++++++++++++++++++++++
>  1 file changed, 33 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/mmc/sdhci-st.txt
>
> diff --git a/Documentation/devicetree/bindings/mmc/sdhci-st.txt b/Documentation/devicetree/bindings/mmc/sdhci-st.txt
> new file mode 100644
> index 0000000..7527db4
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/mmc/sdhci-st.txt
> @@ -0,0 +1,33 @@
> +* STMicroelectronics sdhci-st MMC/SD controller
> +
> +This file documents the differences between the core properties in
> +Documentation/devicetree/bindings/mmc/mmc.txt and the properties
> +used by the sdhci-st driver.
> +
> +Required properties:
> +- compatible :  Must be "st,sdhci"
> +- clock-names : Should be "mmc"
> +                See: Documentation/devicetree/bindings/resource-names.txt
> +- clocks :      Phandle of the clock used by the sdhci controler
> +                See: Documentation/devicetree/bindings/clock/clock-bindings.txt
> +
> +Optional properties:
> +- non-removable: non-removable slot
> +                 See: Documentation/devicetree/bindings/mmc/mmc.txt
> +- bus-width: Number of data lines
> +                 See: Documentation/devicetree/bindings/mmc/mmc.txt
> +
> +Example:
> +
> +mmc0: sdhci at fe81e000 {
> +       compatible      = "st,sdhci";
> +       status          = "disabled";
> +       reg             = <0xfe81e000 0x1000>;
> +       interrupts      = <GIC_SPI 127 IRQ_TYPE_NONE>;
> +       interrupt-names = "mmcirq";
> +       pinctrl-names   = "default";
> +       pinctrl-0       = <&pinctrl_mmc0>;
> +       clock-names     = "mmc";
> +       clocks          = <&clk_s_a1_ls 1>;
> +       bus-width       = <8>
> +};
> --
> 1.9.1
>