[PATCH v3 2/9] mtd: nand: add ONFI timing mode to nand_timings converter

Brian Norris computersforpeace at gmail.com
Wed Jul 9 10:25:55 PDT 2014


Hi Boris,

Since I think you were planning on revisiting this soon, I have one more
comment:

On Wed, Mar 12, 2014 at 07:07:37PM +0100, Boris BREZILLON wrote:
> diff --git a/drivers/mtd/nand/Makefile b/drivers/mtd/nand/Makefile
> index c970ce7..0b8a822 100644
> --- a/drivers/mtd/nand/Makefile
> +++ b/drivers/mtd/nand/Makefile
> @@ -2,7 +2,7 @@
>  # linux/drivers/nand/Makefile
>  #
>  
> -obj-$(CONFIG_MTD_NAND)			+= nand.o
> +obj-$(CONFIG_MTD_NAND)			+= nand.o nand_timings.o

This is not the right place, as it will generate a new module
'nand_timings' (nand_timings.ko, if CONFIG_MTD_NAND=m). You probably
want to just add nand_timings.o to the 'nand-objs' list at the bottom of
the Makefile, like this:

	nand-objs := nand_base.o nand_bbt.o nand_timings.o

>  obj-$(CONFIG_MTD_NAND_ECC)		+= nand_ecc.o
>  obj-$(CONFIG_MTD_NAND_BCH)		+= nand_bch.o
>  obj-$(CONFIG_MTD_NAND_IDS)		+= nand_ids.o nand_hynix.o

Thanks,
Brian



More information about the linux-arm-kernel mailing list