[PATCH v2 2/2] spi: add driver for Rockchip RK3xxx SoCs integrated SPI

[Jonas Gorski]

On Fri, Jul 4, 2014 at 8:32 PM, Mark Brown <broonie at kernel.org> wrote:
> On Tue, Jul 01, 2014 at 09:03:59AM +0800, addy ke wrote:
>> In order to facilitate understanding, rockchip SPI controller IP design
>> looks similar in its registers to designware. But IC implementation
>> is different from designware, So we need a dedicated driver for Rockchip
>> RK3XXX SoCs integrated SPI. The main differences:
>
> This looks good overall, a nice clean driver.  I've applied it but there
> are a few small issues that need fixing up which I've noted below, can
> you please send followup patches dealing with these?
>
>> +      * static void spi_set_cs(struct spi_device *spi, bool enable)
>> +      * {
>> +      *              if (spi->mode & SPI_CS_HIGH)
>> +      *                      enable = !enable;
>> +      *
>> +      *              if (spi->cs_gpio >= 0)
>> +      *                      gpio_set_value(spi->cs_gpio, !enable);
>> +      *              else if (spi->master->set_cs)
>> +      *              spi->master->set_cs(spi, !enable);
>> +      * }
>> +      *
>> +      * Note: enable(rockchip_spi_set_cs) = !enable(spi_set_cs)
>> +      */
>
> So, the point here is that chip select is an active low signal by
> default which means that if chip select is asserted we have a low logic
> level and the parameter means "asserted" not "logic level for the
> output".  It doesn't really matter but it might be clearer to say so
> directly.
>
>> +     if (spi->mode & SPI_CS_HIGH) {
>> +             dev_err(rs->dev, "spi_cs_hign: not support\n");
>> +             return -EINVAL;
>
> Typo here (high).

This whole check looks bogus and should probably be removed. Either
the driver/hardware does not support SPI_CS_HIGH, then the
master->mode_bits set in rockchip_spi_probe are wrong and SPI_CS_HIGH
should be removed. The common code already ensures that spi_device's
mode match the master's mode_bits, so the condition then could never
be true.
Or the driver/hardware does actually support it as it claims with it
mode_bits, then the check is wrong and it will wrongfully rejects
spi_devices using/requiring SPI_CS_HIGH.

Going that the rockchip_spi_set_cs has this extra explanation about
enable being inverted with CS_HIGH, I would guess the latter.


Jonas