[PATCH v7 16/24] regulator: max77686: Setup DVS-related GPIOs on probe
Javier Martinez Canillas
javier.martinez at collabora.co.uk
Fri Jul 4 13:24:19 PDT 2014
MAX77686 PMIC support Dyamic Voltage Scaling (DVS) on a set
of Buck regulators. A number of GPIO are connected to these
lines and are requested by the mfd driver. Setup the GPIO
pins from the regulator driver.
Signed-off-by: Javier Martinez Canillas <javier.martinez at collabora.co.uk>
---
drivers/regulator/max77686.c | 34 ++++++++++++++++++++++++++++++++++
1 file changed, 34 insertions(+)
diff --git a/drivers/regulator/max77686.c b/drivers/regulator/max77686.c
index ef1af2d..ecce77a 100644
--- a/drivers/regulator/max77686.c
+++ b/drivers/regulator/max77686.c
@@ -435,6 +435,12 @@ static int max77686_pmic_dt_parse_pdata(struct platform_device *pdev,
}
#endif /* CONFIG_OF */
+static inline bool max77686_is_dvs_buck(int id)
+{
+ /* BUCK 2,3 and 4 support DVS */
+ return (id >= MAX77686_BUCK2 && id <= MAX77686_BUCK4);
+}
+
static int max77686_pmic_probe(struct platform_device *pdev)
{
struct max77686_dev *iodev = dev_get_drvdata(pdev->dev.parent);
@@ -442,6 +448,9 @@ static int max77686_pmic_probe(struct platform_device *pdev)
struct max77686_data *max77686;
int i, ret = 0;
struct regulator_config config = { };
+ unsigned int reg;
+ int buck_default_idx;
+ int buck_old_idx;
dev_dbg(&pdev->dev, "%s\n", __func__);
@@ -472,13 +481,34 @@ static int max77686_pmic_probe(struct platform_device *pdev)
config.driver_data = max77686;
platform_set_drvdata(pdev, max77686);
+ buck_default_idx = pdata->buck_default_idx;
+ buck_old_idx = max77686_read_gpios(pdata);
+
for (i = 0; i < MAX77686_REGULATORS; i++) {
struct regulator_dev *rdev;
+ int id = pdata->regulators[i].id;
config.init_data = pdata->regulators[i].initdata;
config.of_node = pdata->regulators[i].of_node;
max77686->opmode[i] = regulators[i].enable_mask;
+
+ if (max77686_is_dvs_buck(id)) {
+ /* Try to copy over data so we keep firmware settings */
+ reg = regulators[i].vsel_reg;
+
+ ret = regmap_reg_copy(iodev->regmap,
+ reg + buck_default_idx,
+ reg + buck_old_idx);
+
+ if (ret)
+ dev_warn(&pdev->dev, "Copy err %d => %d (%d)\n",
+ reg + buck_old_idx,
+ reg + buck_default_idx, ret);
+
+ regulators[i].vsel_reg += buck_default_idx;
+ }
+
rdev = devm_regulator_register(&pdev->dev,
®ulators[i], &config);
if (IS_ERR(rdev)) {
@@ -488,6 +518,10 @@ static int max77686_pmic_probe(struct platform_device *pdev)
}
}
+ ret = max77686_setup_gpios(iodev->dev);
+ if (ret)
+ return ret;
+
return 0;
}
--
2.0.0.rc2
More information about the linux-arm-kernel
mailing list