[PATCH v5 14/14] ARM: dts: Add max77802 to exynos5420-peach-pit and exynos5800-peach-pi

Javier Martinez Canillas javier.martinez at collabora.co.uk
Wed Jul 2 02:22:42 PDT 2014


Hello Tushar,

Thanks a lot for your feedback.

On 07/02/2014 11:20 AM, Tushar Behera wrote:
> On 06/26/2014 11:45 PM, Javier Martinez Canillas wrote:
>> Peach pit and pi boards uses a Maxim 77802 power management
>> IC to drive regulators and its Real Time Clock. This patch
>> adds support for this chip.
>> 
>> These are the device nodes and pinctrl configuration that
>> are present on the Peach pit DeviceTree source file in the
>> the Chrome OS kernel 3.8 tree.
>> 
>> Signed-off-by: Javier Martinez Canillas <javier.martinez at collabora.co.uk>
>> Tested-by: Naveen Krishna Chatradhi <ch.naveen at samsung.com>
>> ---
> 
> [ ... ]
> 
>> +
>> +		regulators {
>> +			buck1_reg: BUCK1 {
>> +				regulator-name = "vdd_mif";
>> +				regulator-min-microvolt = <800000>;
>> +				regulator-max-microvolt = <1300000>;
>> +				regulator-always-on;
>> +				regulator-boot-on;
>> +				regulator-ramp-delay = <12500>;
>> +			};
> 
> IMO, adding a blank line between sub-nodes would be better.
> 

Ok

>> +			buck2_reg: BUCK2 {
>> +				regulator-name = "vdd_arm_real";
>> +				regulator-min-microvolt = <800000>;
>> +				regulator-max-microvolt = <1500000>;
>> +				regulator-always-on;
>> +				regulator-boot-on;
>> +				regulator-ramp-delay = <12500>;
>> +			};
> 
> [ ... ]
> 
>> +			vqmmc_sdcard: ldo4_reg: LDO4 {
>> +				regulator-name = "vdd_sd";
>> +				regulator-min-microvolt = <1800000>;
>> +				regulator-max-microvolt = <2800000>;
>> +				regulator-always-on;
>> +
> 
> Blank line, can be removed.
>

Ok

>> +			};
> 
> [ ... ]
>> +			ldo23_reg: LDO23 {
>> +				regulator-name = "ld0_23";
> 
> ldo_23, 'o' in place of '0'.
>

Right, missed that. Thanks for pointing out.

> Similar comments for peach-pi DTS file.
> 

Best regards,
Javier



More information about the linux-arm-kernel mailing list