[PATCH] ARM: dts: Add TMU dt node to monitor the temperature for Exynos3250

[Chanwoo Choi]

On 07/01/2014 01:10 PM, Sachin Kamat wrote:
> Hi Chanwoo,
> 
> On Tue, Jul 1, 2014 at 9:34 AM, Chanwoo Choi <cw00.choi at samsung.com> wrote:
>> Hi Sachin,
>>
>> On 07/01/2014 12:33 PM, Sachin Kamat wrote:
>>> Hi Chanwoo,
>>>
>>> On Tue, Jul 1, 2014 at 6:10 AM, Chanwoo Choi <cw00.choi at samsung.com> wrote:
>>>> This patch add TMU (Thermal Management Unit) dt node to monitor the high
>>>> temperature for Exynos3250.
>>>>
>>>> Signed-off-by: Chanwoo Choi <cw00.choi at samsung.com>
>>>> Acked-by: Kyungmin Park <kyungmin.park at samsung.com>
>>>> ---
>>>> This patch has a dependency on following patch [1]:
>>>>  [1] https://lkml.org/lkml/2014/6/30/805
>>>>
>>>>  arch/arm/boot/dts/exynos3250.dtsi | 10 ++++++++++
>>>>  1 file changed, 10 insertions(+)
>>>>
>>>> diff --git a/arch/arm/boot/dts/exynos3250.dtsi b/arch/arm/boot/dts/exynos3250.dtsi
>>>> index 3660cab..1e566af 100644
>>>> --- a/arch/arm/boot/dts/exynos3250.dtsi
>>>> +++ b/arch/arm/boot/dts/exynos3250.dtsi
>>>> @@ -192,6 +192,16 @@
>>>>                         status = "disabled";
>>>>                 };
>>>>
>>>> +               tmu: tmu at 100C0000 {
>>>> +                       compatible = "samsung,exynos3250-tmu";
>>>> +                       interrupt-parent = <&gic>;
>>>> +                       reg = <0x100C0000 0x100>;
>>>> +                       interrupts = <0 216 0>;
>>>> +                       clocks = <&cmu CLK_TMU_APBIF>;
>>>> +                       clock-names = "tmu_apbif";
>>>> +                       status = "disabled";
>>>
>>> I don't think there would be any board specific properties needed. Hence
>>> leave the status as enabled (by deleting the above line).
>>>
>>
>> I think that if specific board need TMU feature, dts file for specific board
>> should include tmu dt node with 'okay' status. The specific board based on
>> Exynos3250 might not need TMU feature.
> 
> The status field in DT node is not meant for stating the build configuration but
> represents the readiness of the hardware for usage on the platform. If
> a particular
> board does not need this feature it needs to be disabled in the build
> config and only
> for any special requirements disable it in board file.

TMU (Thermal Management Unit) needs specific regulator for TMU power as following:
The regulator for TMU is dependent on board.

For exmaple: in board dts file including tmu dt

	&tmu {
		vtmu-supply = <&ldo7_reg>;
		status = "okay";
	};