[PATCH 4/4] ARM: mvebu: add armada drm init to Dove board setup

[Russell King - ARM Linux]

On Tue, Jul 01, 2014 at 03:40:14PM +0200, Sebastian Hesselbarth wrote:
> On 07/01/2014 03:36 PM, Russell King - ARM Linux wrote:
>> On Tue, Jul 01, 2014 at 03:21:41PM +0200, Sebastian Hesselbarth wrote:
>>> On 07/01/2014 03:10 PM, Russell King - ARM Linux wrote:
>>>> On Tue, Jul 01, 2014 at 03:04:31PM +0200, Sebastian Hesselbarth wrote:
>>>> If you want to do this then you need to add the endpoints from the start
>>>> even though the driver doesn't yet make use of them - or don't add the
>>>> DT bits at all.
>>>
>>> If you really think that way, I definitely give up on mainline Dove and
>>> SolidRun Cubox. You are /really/ proposing to wait for *all* related
>>> subsystem bindings to settle before even starting to add DT support?
>>
>> *Sigh*.
>
> Russell,
>
> honestly, I am out. Feel free to take over anything you want. I
> understand you are in a bad mood because you feel ignored on your
> patches, but for me your attitude is unbearable and *the* reason
> to step back now.

That's fine, and probably for the best, since you appear not to be able
to take part in the completely reasonable technical discussion in this
thread.

I wish you all the best in your future endeavours.

-- 
FTTC broadband for 0.8mile line: now at 9.7Mbps down 460kbps up... slowly
improving, and getting towards what was expected from it.