[PATCH 0/3] RFC/RFT: Powering on MMC Wifi/BT modules in MMC core

[Russell King - ARM Linux]

On Sun, Jan 19, 2014 at 07:56:52PM -0800, Olof Johansson wrote:
> This is a small series enhancing the MMC core code to power on modules
> before the host in cases where needed, and the corresponding DT bindings
> changes.
> 
> I've got some other issues to debug on the Chromebook, i.e. the interface
> doens't actually work. So far it seems unrelated to this patch set so
> it's worth posting this and get things going since others need the same
> functionality (i.e Cubox-i).
> 
> As mentioned in the patch in the series, I haven't implemented power-down
> yet, I wanted to make sure that the power-on side will be adequate for
> those who are looking to use it right away.
> 
> Comments/test reports/etc welcome.

So, I thought I'd give this a go on the Cubox-i4, and... it doesn't work
there.  It's not your patches, it's down to sdhci-esdhc-imx.c not using
mmc_of_parse() at all, so those new properties have no way to be used
there.

It doesn't look like it could in its current form use mmc_of_parse(),
as the imx code manually parses some of the generic properties to hand
them into the sdhci layer.  This looks icky, and it looks like something
that should be fixed - why should drivers be parsing the core attributes
themselves?

-- 
FTTC broadband for 0.8mile line: 5.8Mbps down 500kbps up.  Estimation
in database were 13.1 to 19Mbit for a good line, about 7.5+ for a bad.
Estimate before purchase was "up to 13.2Mbit".