[PATCH 1/2] PWM: let of_xlate handlers check args count

[Sascha Hauer]

On Fri, Jan 24, 2014 at 06:42:54AM +0100, Lothar Waßmann wrote:
> Hi,
> 
> > Okay, this works, but there's a problem with pwm-leds.
> > 
> > When the duty cycle is set to zero (when you set the brightness to zero)
> > pwm-leds decides to disable the PWM after configuring it.  This causes
> > the PWM output to be driven low, causing the LED to go to maximum
> > brightness.
> > 
> > So, using the inversion at PWM level doesn't work.
> > 
> The problem is that the driver calls pwm_disable() when the duty cycle is 0.
> This sets the PWM output low independent from the output polarity setting.
> 
> > To make this work correctly, we really need pwm-leds to do the inversion
> > rather than setting the inversion bit in hardware.
> > 
> The same holds for the pwm-backlight driver.
> 
> The easiest fix would be not to call pwm_disable() even for a zero duty
> cycle.

IMO that's the right thing to do anyway due to the different PWM
hardware controllers we have. I'm thinking about the following patch
for some time.

Sascha

--------------------8<--------------------------

>From 9ebbc3d72c71bd97d7fc4458f60ae3ecd5876984 Mon Sep 17 00:00:00 2001
From: Sascha Hauer <s.hauer at pengutronix.de>
Date: Fri, 24 Jan 2014 08:34:16 +0100
Subject: [PATCH] PWM: Document disabled PWM output as undefined

When disabled PWM hardware reacts differently. Some controllers
just stop with their current value, others produce a constant high
or low output, sometimes depending on the output inversion bit. Update
the documentation to reflect that and request from the PWM consumer
drivers to set a constant high/low value with duty cycles of 0/100%
instead of disabling the PWM.

Signed-off-by: Sascha Hauer <s.hauer at pengutronix.de>
---
 Documentation/pwm.txt | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/Documentation/pwm.txt b/Documentation/pwm.txt
index 93cb979..b7e8a31 100644
--- a/Documentation/pwm.txt
+++ b/Documentation/pwm.txt
@@ -44,6 +44,8 @@ After being requested, a PWM has to be configured using:
 int pwm_config(struct pwm_device *pwm, int duty_ns, int period_ns);
 
 To start/stop toggling the PWM output use pwm_enable()/pwm_disable().
+The output of a disabled PWM is undefined. Set the duty cycle to 100%
+for a constant high output and to 0 for constant low output.
 
 Using PWMs with the sysfs interface
 -----------------------------------
-- 
1.8.5.2

-- 
Pengutronix e.K.                           |                             |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |