[PATCH v3 2/2] i2c: New bus driver for the QUP I2C controller

[Philip Elcan]

On 01/17/2014 06:03 PM, Bjorn Andersson wrote:
> From: "Ivan T. Ivanov" <iivanov at mm-sol.com>
> 
> This bus driver supports the QUP i2c hardware controller in the Qualcomm
> MSM SOCs.  The Qualcomm Universal Peripheral Engine (QUP) is a general
> purpose data path engine with input/output FIFOs and an embedded i2c
> mini-core. The driver supports FIFO mode (for low bandwidth	applications)
> and block mode (interrupt generated for each block-size data transfer).
> The driver currently does not support DMA transfers.
> 
> Shamelessly based on codeaurora version of the driver.
> 
> Signed-off-by: Ivan T. Ivanov <iivanov at mm-sol.com>
> [bjorn: updated to reflect i2c framework changes
>         splited up qup_i2c_enable() in enable/disable
>         don't overwrite ret value on error in xfer functions
>         initilize core for each transfer
>         remove explicit pinctrl selection
>         use existing clock instead of setting new core clock]
> Signed-off-by: Bjorn Andersson <bjorn.andersson at sonymobile.com>
> ---

<snip>

> +
> +	io_mode = readl(qup->base + QUP_IO_MODE);
> +
> +	size = QUP_OUTPUT_BLOCK_SIZE(io_mode);
> +	if (size)
> +		qup->out_blk_sz = size * 16;
> +	else
> +		qup->out_blk_sz = 16;
> +
> +	size = QUP_INPUT_BLOCK_SIZE(io_mode);
> +	if (size)
> +		qup->in_blk_sz = size * 16;
> +	else
> +		qup->in_blk_sz = 16;
> +
> +	qup->xfer_time = msecs_to_jiffies(qup->out_fifo_sz);

qup->xfer_time should be set after you calculate qup->out_fifo_sz below.

> +
> +	/*
> +	 * The block/fifo size w.r.t. 'actual data' is 1/2 due to 'tag'
> +	 * associated with each byte written/received
> +	 */
> +	qup->out_blk_sz /= 2;
> +	qup->in_blk_sz /= 2;
> +
> +	size = QUP_OUTPUT_FIFO_SIZE(io_mode);
> +	qup->out_fifo_sz = qup->out_blk_sz * (2 << size);
> +
> +	size = QUP_INPUT_FIFO_SIZE(io_mode);
> +	qup->in_fifo_sz = qup->in_blk_sz * (2 << size);
> +
> +	/*
> +	 * Wait for FIFO number of bytes to be absolutely sure
> +	 * that I2C write state machine is not idle. Each byte
> +	 * takes 9 clock cycles. (8 bits + 1 ack)
> +	 */
> +	qup->wait_idle = qup->one_bit_t * 9;
> +	qup->wait_idle *= qup->out_fifo_sz;
> +
> +	dev_info(qup->dev, "IN:block:%d, fifo:%d, OUT:block:%d, fifo:%d\n",
> +		qup->in_blk_sz, qup->in_fifo_sz,
> +		qup->out_blk_sz, qup->out_fifo_sz);
> +
> +	i2c_set_adapdata(&qup->adap, qup);
> +	qup->adap.algo = &qup_i2c_algo;
> +	qup->adap.nr = pdev->id;
> +	qup->adap.dev.parent = qup->dev;
> +	qup->adap.dev.of_node = pdev->dev.of_node;
> +	strlcpy(qup->adap.name, "QUP I2C adapter", sizeof(qup->adap.name));
> +
> +	ret = i2c_add_numbered_adapter(&qup->adap);
> +	if (!ret) {
> +		pm_runtime_set_autosuspend_delay(qup->dev, MSEC_PER_SEC);
> +		pm_runtime_use_autosuspend(qup->dev);
> +		pm_runtime_enable(qup->dev);
> +		return 0;
> +	}
> +fail:
> +	qup_i2c_disable_clocks(qup);
> +	return ret;
> +}
> +
> +static int qup_i2c_remove(struct platform_device *pdev)
> +{
> +	struct qup_i2c_dev *qup = platform_get_drvdata(pdev);
> +
> +	disable_irq(qup->irq);
> +	qup_i2c_disable_clocks(qup);
> +	i2c_del_adapter(&qup->adap);
> +	pm_runtime_disable(qup->dev);
> +	pm_runtime_set_suspended(qup->dev);
> +	return 0;
> +}
> +
> +#ifdef CONFIG_PM
> +static int qup_i2c_pm_suspend_runtime(struct device *device)
> +{
> +	struct qup_i2c_dev *qup = dev_get_drvdata(device);
> +
> +	dev_dbg(device, "pm_runtime: suspending...\n");
> +	qup_i2c_disable_clocks(qup);
> +	return 0;
> +}
> +
> +static int qup_i2c_pm_resume_runtime(struct device *device)
> +{
> +	struct qup_i2c_dev *qup = dev_get_drvdata(device);
> +
> +	dev_dbg(device, "pm_runtime: resuming...\n");
> +	qup_i2c_enable_clocks(qup);
> +	return 0;
> +}
> +#endif
> +
> +#ifdef CONFIG_PM_SLEEP
> +static int qup_i2c_suspend(struct device *device)
> +{
> +	dev_dbg(device, "system suspend");
> +	qup_i2c_pm_suspend_runtime(device);
> +	return 0;
> +}
> +
> +static int qup_i2c_resume(struct device *device)
> +{
> +	dev_dbg(device, "system resume");
> +	qup_i2c_pm_resume_runtime(device);
> +	pm_runtime_mark_last_busy(device);
> +	pm_request_autosuspend(device);
> +	return 0;
> +}
> +#endif
> +
> +static const struct dev_pm_ops qup_i2c_qup_pm_ops = {
> +	SET_SYSTEM_SLEEP_PM_OPS(
> +		qup_i2c_suspend,
> +		qup_i2c_resume)
> +	SET_RUNTIME_PM_OPS(
> +		qup_i2c_pm_suspend_runtime,
> +		qup_i2c_pm_resume_runtime,
> +		NULL)
> +};
> +
> +static const struct of_device_id qup_i2c_dt_match[] = {
> +	{.compatible = "qcom,i2c-qup"},
> +	{}
> +};
> +MODULE_DEVICE_TABLE(of, qup_i2c_dt_match);
> +
> +static struct platform_driver qup_i2c_driver = {
> +	.probe  = qup_i2c_probe,
> +	.remove = qup_i2c_remove,
> +	.driver = {
> +		.name = "i2c_qup",
> +		.owner = THIS_MODULE,
> +		.pm = &qup_i2c_qup_pm_ops,
> +		.of_match_table = qup_i2c_dt_match,
> +	},
> +};
> +
> +module_platform_driver(qup_i2c_driver);
> +
> +MODULE_LICENSE("GPL v2");
> +MODULE_ALIAS("platform:i2c_qup");
> 


-- 
The Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
hosted by The Linux Foundation