[PATCH v2 06/15] watchdog: orion: Remove unneeded BRIDGE_CAUSE clear

[Ezequiel Garcia]

Sebastian,

On Thu, Jan 23, 2014 at 08:10:49AM -0300, Ezequiel Garcia wrote:
> On Thu, Jan 23, 2014 at 12:49:50AM +0100, Sebastian Hesselbarth wrote:
> [..]
> > > Notice that Ezequiel has added an IRQ handler that just calls panic,
> > > so a spurious interrupt call is VERY VERY BAD.
> > 
> > And I understand that he now clears watchdog's register before
> > requesting an irq. All that is missing is bridge_irq driver clearing
> > CAUSE register after masking all irqs, right?
> > 
> 
> Are you sure clearing the CAUSE register after masking the IRQs will be enough?
> 
> AFAICS, until now nobody unmasks the watchdog IRQ (at least the orion_wdt
> driver didn't request the interruption) but *still* the CAUSE register is set
> upon watchdog expiration. So I would guessed a masked interrupt still raises a
> bit in the CAUSE register.
> 

Let me add some real information instead of my speculations. Taken from
the Kirkwood specification:

Table 136: Mbus-L to Mbus Bridge Interrupt Mask Register
Offset:		0x00020114
Field: 		Mask
Type/InitVal: 	RW 0x0
Description:	There is a mask bit per each cause bit. Mask only affects the
		assertion of interrupt pins. It does not affect the setting of
		bits in the Cause register.

So I guess this is why Jason has been insisting with the introduction of
the irq_startup.

(Just for reference, the little patch I attached yesterday proved to work here.)
-- 
Ezequiel García, Free Electrons
Embedded Linux, Kernel and Android Engineering
http://free-electrons.com