Re: [PATCH v4 3/8] ARM: brcmstb: add debug UART for earlyprintk support

[Alexander Shiyan]

Пятница, 17 января 2014, 11:19 -08:00 от Marc Carino <marc.ceeeee at gmail.com>:
> Add the UART definitions needed to support earlyprintk on brcmstb machines.
> 
> Signed-off-by: Marc Carino <marc.ceeeee at gmail.com>
> Acked-by: Florian Fainelli <f.fainelli at gmail.com>
> ---
>  arch/arm/Kconfig.debug |   16 +++++++++++++++-
>  1 files changed, 15 insertions(+), 1 deletions(-)
> 
> diff --git a/arch/arm/Kconfig.debug b/arch/arm/Kconfig.debug
> index 5765abf..266c699 100644
> --- a/arch/arm/Kconfig.debug
> +++ b/arch/arm/Kconfig.debug
> @@ -94,6 +94,17 @@ choice
>  		depends on ARCH_BCM2835
>  		select DEBUG_UART_PL01X
>  
> +	config DEBUG_BRCMSTB_UART
> +		bool "Use BRCMSTB UART for low-level debug"
> +		depends on ARCH_BRCMSTB
> +		select DEBUG_UART_8250
> +		help
> +		  Say Y here if you want the debug print routines to direct
> +		  their output to the first serial port on these devices.
> +
> +		  If you have a Broadcom STB chip and would like early print
> +		  messages to appear over the UART, select this option.
> +
>  	config DEBUG_CLPS711X_UART1
>  		bool "Kernel low-level debugging messages via UART1"
>  		depends on ARCH_CLPS711X
> @@ -988,6 +999,7 @@ config DEBUG_UART_PHYS
>  	default 0x20064000 if DEBUG_RK29_UART1 || DEBUG_RK3X_UART2
>  	default 0x20068000 if DEBUG_RK29_UART2 || DEBUG_RK3X_UART3
>  	default 0x20201000 if DEBUG_BCM2835
> +	default 0xf0406b00 if DEBUG_BRCMSTB_UART

This should be sorted by address.

---