[PATCH] ACPI: introduce CONFIG_ACPI_REDUCED_HARDWARE_ONLY to enforce this ACPI mode

[Al Stone]

On 01/16/2014 03:55 AM, Arnd Bergmann wrote:
> On Thursday 16 January 2014, Al Stone wrote:
>> On 01/14/2014 02:26 PM, Arnd Bergmann wrote:
>>> On Tuesday 14 January 2014 13:37:02 al.stone at linaro.org wrote:
>>>> +config ACPI_REDUCED_HARDWARE_ONLY
>>>> +       bool "Hardware-reduced ACPI support only"
>>>> +       def_bool n
>>>> +       depends on ACPI && EXPERT
>>>
>>> I think this will cause a Kconfig warning if you try to select this
>>> on ARM64 without turning on EXPERT as well.
>>>
>>> It should be ok if you express it as
>>>
>>> config ACPI_REDUCED_HARDWARE_ONLY
>>>          bool "Hardware-reduced ACPI support only" if EXPERT
>>>          def_bool n
>>>          depends on ACPI
>>>
>>>
>>>        Arnd
>>>
>>
>> I am very puzzled.  I went back and re-did my configs from
>> before, tried a few new ones, and tried with both expressions
>> above, but I could not get a Kconfig warning.  Do you have an
>> example .config that shows the warning?
>>
>
> I don't have a source tree that allows turning on ACPI on arm64
> to easily test this. To clarify: the warning will only happen if
> you also add this piece to arch/arm64/Kconfig:
>
> 	select ACPI_REDUCED_HARDWARE_ONLY if ACPI
>
> 	Arnd
>

Right; I assumed I had to have that SELECT.  My apologies -- I
still cannot reproduce the warning.  I'll resubmit the patch
incorporating the suggestion, though, since the result ends up
being the same -- you must have ACPI and EXPERT selected in order
to enable ACPI_REDUCED_HARDWARE_ONLY.

Thanks.

-- 
ciao,
al
-----------------------------------
Al Stone
Software Engineer
Linaro Enterprise Group
al.stone at linaro.org
-----------------------------------