[PATCH v4 2/4] pinctrl: Add pinctrl binding for Broadcom Capri SoCs

[Sherman Yin]

On 14-01-14 02:16 AM, Linus Walleij wrote:
> On Tue, Jan 7, 2014 at 9:45 PM, Sherman Yin <syin at broadcom.com> wrote:
>> On 14-01-07 09:15 AM, Linus Walleij wrote:
>
>> Is that what you wanted to see in pinctrl-bindings.txt, or is there
>> something else you want to see added to that txt file?  I didn't want to add
>> the description of slew-rate arguments there because this is capri-specific.
>> I'm not quite sure what else to add.
> (...)
>> That doc already says bias-pull-up is specified in Ohm, and the specific
>> values are chip-specific, so I don't think they should be mentioned there.
>
> You're right, forget about this. I didn't realize the pinctrl bindings doc
> was that good...
>
>>>> +Optional Properties (for HDMI pins):
>>>> +
>>>> +- function:                    String. Specifies the pin mux selection.
>>>> Values
>>>> +                               must be one of: "alt1", "alt2", "alt3",
>>>> "alt4"
>>>> +- slew-rate:                   Integer. Controls slew rate.
>>>> +                                       0: Standard(100kbps)&
>>>> Fast(400kbps) mode
>>>> +                                       1: Highspeed (3.4Mbps) mode
>>>
>>> Hmmmm slew rate is not specifiec in "bps" but rather in
>>> something like volts per second. But maybe it's best to keep
>>> this value driver-specific.
>>
>> Right, I think the slew-rates values are capri specific.
>
> OK
>

Great!  Is there anything else you would like to see changed before this 
patchset can be accepted?

Thanks,
Sherman