[PATCH] ARM: Kirkwood: Add DT description of QNAP 419

[Jason Cooper]

On Tue, Jan 14, 2014 at 10:15:43AM +0100, Andrew Lunn wrote:
> On Mon, Jan 13, 2014 at 07:48:33PM -0500, Jason Cooper wrote:
> > On Mon, Jan 06, 2014 at 11:49:17PM +0100, Andrew Lunn wrote:
> > > Re-implement the Marvell Kirkwood ts41x-setup.c in DT.
> > > 
> > > As with the QNAP 119, there are two variants, depending on which SoC
> > > has been used. They differ on Ethernet PHY addresses and number of
> > > PCIe busses.
> > > 
> > > Signed-off-by: Andrew Lunn <andrew at lunn.ch>
> > > ---
> > >  arch/arm/boot/dts/Makefile                |    4 +-
> > >  arch/arm/boot/dts/kirkwood-ts419-6281.dts |   20 ++++++++
> > >  arch/arm/boot/dts/kirkwood-ts419-6282.dts |   32 ++++++++++++
> > >  arch/arm/boot/dts/kirkwood-ts419.dtsi     |   75 +++++++++++++++++++++++++++++
> > >  4 files changed, 130 insertions(+), 1 deletion(-)
> > >  create mode 100644 arch/arm/boot/dts/kirkwood-ts419-6281.dts
> > >  create mode 100644 arch/arm/boot/dts/kirkwood-ts419-6282.dts
> > >  create mode 100644 arch/arm/boot/dts/kirkwood-ts419.dtsi
> > 
> > Applied to mvebu/dt with Ian's Tested-by
> 
> Hi Jason
> 
> Thanks, but please could you hold onto it for a while. I would like to
> see how the discussion about unstable /dev/input/by-path discussion
> plays out. That is if anybody actually replies to my question...

Ok, this and the Bubba board are probably for next cycle at this point
anyhow.  I'll send pulls for the fixes sometime today.

thx,

Jason.