[PATCH v5 2/9] mfd: omap-usb-host: Get clocks based on hardware revision

[Lee Jones]

> Not all revisions have all the clocks so get the necessary clocks
> based on hardware revision.
> 
> This should avoid un-necessary clk_get failure messages that were
> observed earlier.
> 
> Be more strict and always fail on clk_get() error.
> 
> CC: Lee Jones <lee.jones at linaro.org>
> CC: Samuel Ortiz <sameo at linux.intel.com>
> Signed-off-by: Roger Quadros <rogerq at ti.com>
> ---
>  drivers/mfd/omap-usb-host.c | 93 +++++++++++++++++++++++++++++++--------------
>  1 file changed, 64 insertions(+), 29 deletions(-)
> 
> diff --git a/drivers/mfd/omap-usb-host.c b/drivers/mfd/omap-usb-host.c
> index 1c9bca2..7202cc6 100644
> --- a/drivers/mfd/omap-usb-host.c
> +++ b/drivers/mfd/omap-usb-host.c
> @@ -92,7 +92,6 @@
>  #define is_ehci_tll_mode(x)	(x == OMAP_EHCI_PORT_MODE_TLL)
>  #define is_ehci_hsic_mode(x)	(x == OMAP_EHCI_PORT_MODE_HSIC)
>  
> -

Sneaky! ;)

>  struct usbhs_hcd_omap {
>  	int				nports;
>  	struct clk			**utmi_clk;
> @@ -665,22 +664,41 @@ static int usbhs_omap_probe(struct platform_device *pdev)
>  		goto err_mem;
>  	}
>  
> -	need_logic_fck = false;
> +	/* Set all clocks as invalid to begin with */
> +	omap->ehci_logic_fck = omap->init_60m_fclk = ERR_PTR(-EINVAL);
> +	omap->utmi_p1_gfclk = omap->utmi_p2_gfclk = ERR_PTR(-EINVAL);
> +	omap->xclk60mhsp1_ck = omap->xclk60mhsp2_ck = ERR_PTR(-EINVAL);

I don't think this is the correct error code.

-EINVAL means 'invalid parameter'.

You probably want -ENODEV or -ENOSYS ('function not implemented'
probably isn't ideal either tbh, but you get the idea). Perhaps you
can set them as NULL and check for IS_ERR_OR_NULL() instead?

-- 
Lee Jones
Linaro STMicroelectronics Landing Team Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog